|
|
Número de pieza | ATM0500D13 | |
Descripción | LIQUID CRYSTAL DISPLAY | |
Fabricantes | AZ Displays | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de ATM0500D13 (archivo pdf) en la parte inferior de esta página. Total 17 Páginas | ||
No Preview Available ! AZ DISPLAYS
SPECIFICATIONS FOR
LIQUID CRYSTAL DISPLAY
CUSTOMER APPROVAL
※PART NO. : ATM0500D13(AZ DISPLAYS) VER1.2
APPROVAL
COMPANY
CHOP
CUSTOMER
COMMENTS
AZ DISPLAYS ENGINEERING APPROVAL
DESIGNED BY
CHECKED BY
APPROVED BY
SUNHB
1 page ATM0500D13(AZ DISPLAYS)TFT MODULE V1.2
2. PIN ASSIGNMENT
TFT LCD Panel Driving Section
FPC Connector is used for the module electronics interface. The recommended model is
“FH19SC-40S-0.5SH" manufactured by Hirose.
Pin No.
1
2
3
4
5~12
13~20
21~28
29
30
31
32
33
34
35
36
37
38
39
40
Symbol
VLED-
VLED+
GND
VDD
R0~R7
G0~G7
B0~B7
GND
CLK
DISP
HSYNC
VSYNC
DE
NC
GND
NC
NC
NC
NC
Function
Power for LED backlight(Cathode)
Power for LED backlight(Anode)
Ground
Power supply
Red data
Green data
Blue data
Ground
Clock for input data. Data latched
at falling edge of this signal.
Display on/off control.
DISP=“L”, enter standby mode for
power saving. Timing controller
and source driver will turn off, all
outputs are Hi-Z.
DISP=“H”, normal operation.
Note: Normal pull high
Horizontal sync
Vertical sync
Data enable
No connection
Ground
No connection
No connection
No connection
No connection
Level
P
P
P
P
I
I
I
P
I
I
I
I
I
--
P
--
--
--
--
Note
I: input, O: output, P: Power
AZ DISPLAYS
4
5 Page ATM0500D13(AZ DISPLAYS)TFT MODULE V1.2
Note 2: Definition of optical measurement system.
The optical characteristics should be measured in dark room. After 30 minutes operation, the optical properties are
measured at the center point of the LCD screen. (Response time is measured by Photo detector TOPCON
Figure 4.2 Optical measurement system setup
Note 3: Definition of Response time
The response time is defined as the LCD optical switching time interval between “White” state and “Black” state. Rise
time (TON) is the time between photo detector output intensity changed from 90% to 10%. And fall time (TOFF) is the
time between photo detector output intensity changed from 10% to 90%.
AZ DISPLAYS
Figure 4.3 Definition of response.
10
11 Page |
Páginas | Total 17 Páginas | |
PDF Descargar | [ Datasheet ATM0500D13.PDF ] |
Número de pieza | Descripción | Fabricantes |
ATM0500D12 | LCD | AZ Displays |
ATM0500D12-T | LCD | AZ Displays |
ATM0500D13 | LIQUID CRYSTAL DISPLAY | AZ Displays |
ATM0500D13-T | LCD | AZ Displays |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |