|
|
PDF PD69100 Data sheet ( Hoja de datos )
| Número de pieza | PD69100 | |
| Descripción | PoE Controller Unit | |
| Fabricantes | Microsemi | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de PD69100 (archivo pdf) en la parte inferior de esta página. Total 5 Páginas | ||
|
No Preview Available !
®
TM
DESCRIPTION
Microsemi’s™ PoE controller, PD69100, is a cost-
effective, pre-programmed unit designed to implement
Enhanced mode. It is used in conjunction with Microsemi’s
PoE Managers PD69108 and PD69104 in Ethernet
switches to enable next generation network devices to
share power and data over the same cable, as specified in
IEEE802.3af and IEEE802.3at standards. Enhanced
mode operation along with PD69108/PD69104 managers
enables operation in a total Power-over-Ethernet stand-
alone mode.
The controller features an ESPI bus for each PoE device
and a communication interface with Host CPU via UART
or I2C protocol.
Device is based on STMicroelectronics family
STM32F101T6 embedded with ARM Cortex™-M3 core. It
includes the following peripherals:
3 x Timers
2 x Uarts
1 x SPI
1 x I2C
1 x 12-bit analog-to-digital converter
PIN CONFIGURATION
27 26 25 24 23 22 21 20 19
SWCLK 28
xDisable_Ports 29
xHswp_On 30
Spare 31
xSys_OK 32
SCL / UART1_TX 33
SDA / UART1_RX 34
Boot0 35
VSS3 36
<Part Number >
< -Software Ver >
< Date Code >
12 3 4 5 6 7 8 9
18 VSS1
17 Reserved
16 I2C_ADDR
15 HW_VER
14 ESPI_MOSI
13 ESPI_MISO
12 ESPI_SCK
11 ESPI_xCS
10 Reserved
PD69100
PoE Controller Unit
DATASHEET
KEY FEATURES
Controls up to 48 PoE ports (6 x PD69108)
Pre-Standard / Capacitor detection
Detection of Cisco devices
Supports both UART and I2C interfaces to
Host CPU
Backwards compatible with PD69000,
PD63000, PD62000 and PDIC66000
Supports 2 pair RJ or 4 pair RJ
16 power banks support using four discrete
lines connected directly to PD69108 /
PD69104.
Power management for up to 96 ports
Rmode pin for default parameters selection
Programmable over-voltage and under voltage
Predefined power budget; 16 discrete levels
LED stream support
System OK indication
Software download via I2C or UART
System and port measurements
Detailed port status
Thermal protection and monitoring
Programmable temperature alarm limit
Interrupt out pin for system and port events
Forced power for system testing
System reset
Port power limit setting
Port matrix and priority
Automatic PoE device type detection
RoHS compliant
MARKETING DEFINITIONS
Device’s label includes the following:
<Part number> Hardware P/N (for example
PD69100)
<-Software Ver> Software version (for
example. 0120)
<Date Code> Burning date code in the
following format: yyww (yy = year, ww = week)
FIRMWARE DOWNLOAD
Initial burning of controller's firmware is
performed in factory. Firmware upgrades can
be performed by users using communication
interface (see application note 126 catalogue
number 06-0006-080).
ORDERING INFORMATION
Part Number PD69100y-gggg
Detection
y = R: Resistor
y = C: Resistor/legacy
Version
gggg
*For latest firmware version available, refer to Microsemi's website or Customer Care Support.
Copyright © 2010
Microsemi
Rev. 1.1, Dec. 2010
Analog Mixed Signal Group
2381 Morse Avenue, Irvine, CA 92614, USA; Within the USA: (800) 713-4113, Outside the USA: (949) 221-7100 Fax: (949) 756-0308
1
1 page  
PD69100
TM ® PoE Controller Unit
DATASHEET
The information contained in the document is PROPRIETARY AND CONFIDENTIAL information of Microsemi and
cannot be copied, published, uploaded, posted, transmitted, distributed or disclosed or used without the express
duly signed written consent of Microsemi If the recipient of this document has entered into a disclosure agreement
with Microsemi, then the terms of such Agreement will also apply . This document and the information contained
herein may not be modified, by any person other than authorized personnel of Microsemi. No license under any
patent, copyright, trade secret or other intellectual property right is granted to or conferred upon you by disclosure
or delivery of the information, either expressly, by implication, inducement, estoppels or otherwise. Any license
under such intellectual property rights must be approved by Microsemi in writing signed by an officer of Microsemi.
Microsemi reserves the right to change the configuration, functionality and performance of its products at anytime
without any notice. This product has been subject to limited testing and should not be used in conjunction with life-
support or other mission-critical equipment or applications. Microsemi assumes no liability whatsoever, and
Microsemi disclaims any express or implied warranty, relating to sale and/or use of Microsemi products including
liability or warranties relating to fitness for a particular purpose, merchantability, or infringement of any patent,
copyright or other intellectual property right. The product is subject to other terms and conditions which can be
located on the web at http://www.microsemi.com/legal/tnc.asp
Revision History
Revision Level / Date
0.1 / 15 February 2010
Para. Affected
0.2 Dec 2010
1.1 / Jan 2011
Description
Initial release
Ordering information update
Updating template and proofing
© 2009 Microsemi Corp.
All rights reserved.
For support contact: [email protected]
Visit our web site at: www.microsemi.com
Cat. No. DS_PD69100
Copyright © 2010
Microsemi
Rev. 1.1, Dec. 2010
Analog Mixed Signal Group
2381 Morse Avenue, Irvine, CA 92614, USA; Within the USA: (800) 713-4113, Outside the USA: (949) 221-7100 Fax: (949) 756-0308
5
5 Page | ||
| Páginas | Total 5 Páginas | |
| PDF Descargar | [ Datasheet PD69100.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| PD69100 | PoE Controller Unit | Microsemi |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |