Datenblatt-pdf.com


W58300 Schematic ( PDF Datasheet ) - Winbond

Teilenummer W58300
Beschreibung Voice Synthesizer
Hersteller Winbond
Logo Winbond Logo 




Gesamt 12 Seiten
W58300 Datasheet, Funktion
W58300
Voice Synthesizer
(ROM-LESS High Fidelity PowerSpeech )TM
GENERAL DESCRIPTION
The High Fidelity PowerSpeechTM family is a new member of the PowerSpeechTM synthesizer series,
with voice quality which is even better than before. The W58300 is a ROMless chip that can support
up to maximal 16M bits memory size; the voice length can reach 8.5 minutes. Combined with flash
memory W55Fxx, this chip can be used to demonstrate real chip function before mass-production.
This family has adopted the same architecture as the PowerSpeechTM synthesizers while replacing
the 4-bit ADPCM algorithm with Winbonds high fidelity synthesis algorithm to produce better quality
voice. W58300 provides hardware Infrared(IR) circuit, CPU interface and voice output in D/A
converter (DAC) or PWM type.
FEATURES
Programmable voice synthesizer
Proprietary synthesis algorithm
Direct drive speaker by PWM output or by 8-bit DAC with external transistor
Wide operating voltage range: 2.45.5 Volts
Addressing capability up to 16M bits
IR interface for command Transmission and Receiving
TX, INC and MV instruction provided
8 trigger inputs - with separate control of falling/rising edge trigger
8 STOP outputs
Supports CPU interface operation
Pad option for Ring or Crystal oscillator
Symbolic compiler supported
Instruction cycle 400 µS typically
Section control
Variable frequency: 4.8/6/8/12 KHz
LED: ON/OFF
Eight general-purpose registers R0R7
Number of interrupt vector/label up to 2,048
Publication Release Date: March 1999
- 1 - Revision A2






W58300 Datasheet, Funktion
W58300
3. PAGE Register
BIT
PAGE
7
-
6
-
54 3 2 1 0
- PG4 PG3 PG2 PG1 PG0
Bits 57 of PAGE register are reserved; bits 04 are used for page selection. The user must set the
page mode configuration described in the Option Control declaration. Once the page mode is
decided, the working page is selected by the bits 04 of PAGE register. Hence, the user can execute
"LD PAGE, value" instruction to change the working page of the interrupt vector/label. Not all of the
bits 04 of PAGE register are used in different page mode; they are listed below.
PAGE MODE PG4 PG3 PG2 PG1 PG0
1-page
×××××
8-page
××√√√
16-page
×√√√√
32-page
√√√√√
Where "×" means dont care and "" means must be set properly.
4. EN0, EN1 Registers
BIT 7
6
EN0 TG4R TG3R
EN1 TG8R TG7R
5
TG2R
TG6R
4
TG1R
TG5R
3
TG4F
TG8F
2
TG3F
TG7F
1
TG2F
TG6F
0
TG1F
TG5F
A "1" means "enabled", while a "0" means "disabled" for that edge of the particular TG pin. For
example, the instruction "LD EN0, 0x0F" enables all the falling edge triggers of TG1TG4, while
disabling all the rising edge triggers of TG1TG4. The user can modify the EN0 and EN1 registers
during operation of the W58300 to achieve various kinds of trigger functions, like retriggerable or not,
one shot or level hold play mode, etc.
That is to say, users can change the contents of EN0, EN1 register during synthesis at will to
determine which trigger pin is to be enabled or disabled for its falling/rising edge.
5. STOP Register
BIT 7 6 5 4 3 2 1 0
STOP STH STG STF STE STD STC STB STA
The STOP register is used to control the status of the STPASTPH pins. For example, STB = 1
means that pin is in high state and STB = 0 means low state.
6. R0R7 Registers
These eight registers are general purpose registers. They can be used to hold interrupt vector/label.
R0 is a special register which can be incremented by "INC" instruction.
-6-

6 Page









W58300 pdf, datenblatt
Revise Output Current of SPK+, SPK- parameter
7. AC CHARACTERISTIC
Revise Oscillation Frequency parameter
Revise Oscillation Frequency Deviation by Voltage Drop parameter
Revise Long Debounce Time parameter
Revise Short Debounce Time parameter
W58300
Headquarters
Winbond Electronics (H.K.) Ltd.
No. 4, Creation Rd. III,
Science-Based Industrial Park,
Hsinchu, Taiwan
TEL: 886-3-5770066
FAX: 886-3-5792697
Rm. 803, World Trade Square, Tower II,
123 Hoi Bun Rd., Kwun Tong,
Kowloon, Hong Kong
TEL: 852-27513100
FAX: 852-27552064
http://www.winbond.com.tw/
Voice & Fax-on-demand: 886-2-27197006
Taipei Office
11F, No. 115, Sec. 3, Min-Sheng East Rd.,
Taipei, Taiwan
TEL: 886-2-27190505
FAX: 886-2-27197502
Note: All data and specifications are subject to change without notice.
Winbond Electronics North America Corp.
Winbond Memory Lab.
Winbond Microelectronics Corp.
Winbond Systems Lab.
2727 N. First Street, San Jose,
CA 95134, U.S.A.
TEL: 408-9436666
FAX: 408-5441798
- 12 -

12 Page





SeitenGesamt 12 Seiten
PDF Download[ W58300 Schematic.PDF ]

Link teilen




Besondere Datenblatt

TeilenummerBeschreibungHersteller
W58300Voice SynthesizerWinbond
Winbond

TeilenummerBeschreibungHersteller
CD40175BC

Hex D-Type Flip-Flop / Quad D-Type Flip-Flop.

Fairchild Semiconductor
Fairchild Semiconductor
KTD1146

EPITAXIAL PLANAR NPN TRANSISTOR.

KEC
KEC


www.Datenblatt-PDF.com       |      2020       |      Kontakt     |      Suche