|
|
Número de pieza | CLAA215FA03 | |
Descripción | Display Module | |
Fabricantes | CHUNGHWA PICTURE TUBES | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de CLAA215FA03 (archivo pdf) en la parte inferior de esta página. Total 23 Páginas | ||
No Preview Available ! Global LCD Panel Exchange Center
www.panelook.com
Chunghwa Picture Tubes, Ltd.
Technical Specification
CPT TFT-LCD
CLAA 215FA03
APPROVED BY
CHECKED BY
PREPARED BY
Prepared by: Design General Division
CHUNGHWA PICTUER TUBES, LTD.
No. 1, Huaying Rd., Sanho Tsun, Lungtan Shiang, Taoyuan, Taiwan, 325, R.O.C.
TEL: +886-3-4805678 FAX: +886-3-4800589
Doc. No:
CLAA215FA03-A
Date:
2009/02/26
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
1 page Global LCD Panel Exchange Center
www.panelook.com
TitleΚCLAA215FA03
CHUNGHWA PICTUER TUBES, LTD.
TECHNICAL SPECIFICATION
Technical Specification
Doc. NoΚʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ
VersionΚʳ ʳ ʳ ʳ ʳ ʳ ʳ ˔ʳ ʳ ʳ ʳ ʳ ʳ
Issue Date Κʳ ʳ ʳ ˅˃˃ˌ˂˃˅˂˅ˉʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ
2. ABSOLUTE MAXIMUM RATINGS
ITEM
SYMBOL MIN. MAX.
UNIT REMARK
Power Supply Voltage for LCD VCC
0
6
V
Lamp Voltage
Delta
STI
VL 780 930 Vrms
VL 760 950
Lamp Current
Delta
STI
ILO 3
ILO 3
8
8
mArms
Lamp Frequency
static electricity
FL
VESDt
VESDc
40
-200
-8000
80
200
8000
kHz
V
V
*5)
Operation Temperature Top 0 50 ć *1). 2). 3). 6)
Storage Temperature
Tstg -20
60
ć *1). 2). 3)
Delayed Discharge Time
TD
--
1
sec *8)
[Note]
1).The relative temperature and humidity range are as below sketch, 90%RHMax.(Ta̰40ć).
2).The maximum wet bulb temperature ̰39ć(TaЇ40ć) and without dewing.
3).If you use the product in an environment which over the definition of temperature and humidity too
long to effect the result of eye-etching.
4).The life time of the lamp is related to the current of the lamp, so please according to the description
of the “(b) backlight” on page 7.
5).Test Condition: IEC 1000-4-2 VESDt: Contact discharge to input connector; VESDC: Contact
discharge to module
6).If you operate the product in normal temperature range, the center surface of panel should be under
50ć.
7).When lamp current is out of the absolute maximum range, the life will fall rapidly or shown
unusual sign.
IL min 2mA only for test only, but we can’t guarantee the lifetime and performance.
8).Delay lighting testing needs the volt above start voltage Vrms. Before the procedure tube needs
typical lighting for 1 minute and stay in the temperature 25±2ć for 24 hours and then testing in the
same condition in dark room.
˜˦ˢʳ˗˴̇˴̆˻˸˸̇ʳˡ̂ˍʳT-3010004-008-F
CHUNGHWA PICTUER TUBES, LTD.
Datasheet Version.: 01ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ
Page: 5042
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
5 Page Global LCD Panel Exchange Center
www.panelook.com
TitleΚCLAA215FA03
CHUNGHWA PICTUER TUBES, LTD.
TECHNICAL SPECIFICATION
Technical Specification
Doc. NoΚʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ
VersionΚʳ ʳ ʳ ʳ ʳ ʳ ʳ ˔ʳ ʳ ʳ ʳ ʳ ʳ
Issue Date Κʳ ʳ ʳ ˅˃˃ˌ˂˃˅˂˅ˉʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ
8) WL=IL x VL x 2Ζ(IL=7.5mAΔTa=25ć)
9) The Starting Lamp Voltage (VS) of inverter must be driven large than one second.
10) The output voltage of inverter (Vn) must be the same phase of between any lamps.
11) The difference in voltage between any lamps (ƸV) must be smaller than 300V at the same time.
ExampleΚ̮ƸV̮І300VΔƸVΚ = V1(t)-V2(t)
Vnrms − VL
≤ 15%
12) VL
Δn=1Δ2… 4ΔnΚthe number of lamp
ϦV
˩˄ʻ̇ʼ
˩˅ʻ̇ʼ
13) The lamp working current (Icyc) of any cycle of lighting driving wave can’t exceed maximum of
lamp standard working current (IL).Therefore, the inverter design should be avoided the state.
NoteΚ
1. VLΚThe lamp voltage(typical) of the standard working current.
2. The lamp working current (Icyc) is defined the RMS of current cycle from the oscilloscope.
˜˦ˢʳ˗˴̇˴̆˻˸˸̇ʳˡ̂ˍʳT-3010004-008-F
CHUNGHWA PICTUER TUBES, LTD.
Datasheet Version.: 01ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ ʳ
Page: 11042
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
11 Page |
Páginas | Total 23 Páginas | |
PDF Descargar | [ Datasheet CLAA215FA03.PDF ] |
Número de pieza | Descripción | Fabricantes |
CLAA215FA01 | Display Module | CHUNGHWA PICTURE TUBES |
CLAA215FA01-V2 | Display Module | CHUNGHWA PICTURE TUBES |
CLAA215FA03 | Display Module | CHUNGHWA PICTURE TUBES |
CLAA215FA03S | TFT LCD | CHUNGHWA PICTURE TUBES |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |