CLAA185WA03L Datasheet PDF - CHUNGHWA PICTURE TUBES
| Part Number | CLAA185WA03L | |
| Description | Display Module | |
| Manufacturers | CHUNGHWA PICTURE TUBES | |
| Logo |  |
|
|
There is a preview and CLAA185WA03L download ( pdf file ) link at the bottom of this page. Total 25 Pages | ||
Preview 1 page No Preview Available !
Chunghwa Picture Tubes, Ltd.
Technical Specification
To : Qisda (Dell IN1920)
Date : 2010/8/09
CPT TFT-LCD
CLAA 185WA03
(AL7, AN8)
L
ACCEPTED BY：
APPROVED BY
Kevin Chen
CHECKED BY
Edward Lee
PREPARED BY
General Design
Division
VD Business Unit
Prepared by : General Design Division VD Business Unit
CHUNGHWA PICTUER TUBES, LTD.
No. 1, Huaying Rd., Sanho Tsun, Lungtan Shiang, Taoyuan, Taiwan, 325, R.O.C.
TEL: +886-3-4805678 FAX: +886-3-4800589
Doc. No: CLAA185WA03 L_V2-Qisda-20100629 Issue Date: 2010/08/09
|
| |
 
CPT
CHUNGHWA PICTURES TUBES, LTD.,
2. ABSOLUTE MAXIMUM RATINGS
ITEM
SYMBOL
Power Supply Voltage for LCD VCC
Lamp Voltage
VL
MIN.
0
715
730
MAX.
6
830
890
UNIT
V
Vrms
REMARK
Delta
STI
Lamp Current
ILO 3
8
mArms
*4). 7)
Lamp Frequency
static electricity
Operation Temperature
Storage Temperature
Delayed Discharge Time
FL
VESDt
VESDc
Top
Tstg
TD
40
-200
-8000
0
-20
--
80
200
8000
50
60
1
kHz
V
V
*5)
℃ *1). 2). 3). 6)
℃ *1). 2). 3)
sec *8)
[Note]
1).The relative temperature and humidity range are as below sketch, 90%RHMax.(Ta≦40℃).
2).The maximum wet bulb temperature ≦39℃(Ta＞40℃) and without dewing.
3).If you use the product in a environment which over the definition of temperature and humidity
too long to effect the result of eye-aching.
4).The life time of the lamp is related to the current of the lamp, so please according to the
description of the “(2) backlight” on page 8.
5).Test Condition: IEC 1000-4-2
VESDt: Contact discharge to input connector; VESDC: Contact discharge to module
6).If you operate the product in normal temperature range, the center surface of panel should be
under 60℃.
7).When lamp current is out of the absolute maximum range, the life will fall rapidly or shown
unusual sign.
IL min 2mA only for test only, but we can’t guarantee the lifetime and performance.
8).Delay lighting testing needs the volt above start voltage Vrms. Before the procedure tube needs
typical lighting for 1 minute and stay in the temperature 25±2℃ for 24 hours and then testing
in the same condition in dark room.
CPT Confidential
5/25 CLAA185WA03 L-V2-Qisda-20100809
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for CLAA185WA03L electronic component. |
| Information | Total 25 Pages | |
| Link URL | [ Copy URL to Clipboard ] | |
| Download | [ CLAA185WA03L.PDF Datasheet ] | |
Share Link :
Electronic Components Distributor
|
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
| SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
| Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
| Part Number | Description | MFRS |
| CLAA185WA03 | The function is Display Module. CHUNGHWA PICTURE TUBES | |
| CLAA185WA03L | The function is Display Module. CHUNGHWA PICTURE TUBES | |
Semiconductors commonly used in industry:
1N4148 |
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
CLAA
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA | ||