Datenblatt-pdf.com


GL641USB Schematic ( PDF Datasheet ) - ETC

Teilenummer GL641USB
Beschreibung USB ATA/ATAPI/ COMPACT FLASH CARD CONTROLLER
Hersteller ETC
Logo ETC Logo 




Gesamt 7 Seiten
GL641USB Datasheet, Funktion
Your Imagination, Our Creation
GL641USB
USB ATA/ATAPI/
COMPACT FLASH CARD
CONTROLLER
SPECIFICATION REVISION 1.2
June 1, 2001
Genesys Logic, Inc.
10F, No.11, Ln.3, Tsao Ti Wei, Shenkeng, Taipei, Taiwan
Tel: 886-2-2664-6655 Fax: 886-2-2664-5757
http://www.genesyslogic.com






GL641USB Datasheet, Funktion
GL641USB
4. General Purpose I/O Ports
The GL641USB interface with peripherals is conducted via up to 8 GPIO signals. Host driver can control all of these
I/O pins directly. The GL641USB provides 3 vendor specific control transfer functions to host driver. One of these
functions is used to set I/O pins direction. One is used to read data from I/O pins. And the other one is used to write
data to I/O pins.
GPIO1 is used as a power on strapping to distinguish the application is used for Compact Flash card or other
ATA/ATAPI device. If this pin is pulled up when USB bus reset, GL641USB will treat the connected device is a
Compact Flash card. Otherwise, GL641USB will assume the connected device is an ATA/ATAPI device.
GPIO2 is used as power control signal for bus powered device, especially for Compact Flash card reader. Hence USB
bus powered device must consume less than 500uA when suspend mode, power of the Compact Flash card should be
turned off when system suspend.
GPIO3 is connected to external reset pin of ATA/ATAPI/Compact Flash card. The GL641USB can only work at True
IDE mode when Compact Flash card is connected.
GPIO4~GPIO7 are used as serial EEPROM interface. System maker can write their own vendor ID and product ID
into the serial EEPROM by a test program provided by Genesys Logic.
GPIO8 is used for Compact Flash card reader. This pin is pulled up by a resistor on board and connected to ground
when Compact Flash card is inserted. This is used as a card detection signal.
Revision 1.2
-5- June 1, 2001

6 Page







SeitenGesamt 7 Seiten
PDF Download[ GL641USB Schematic.PDF ]

Link teilen




Besondere Datenblatt

TeilenummerBeschreibungHersteller
GL641USBUSB ATA/ATAPI/ COMPACT FLASH CARD CONTROLLERETC
ETC

TeilenummerBeschreibungHersteller
CD40175BC

Hex D-Type Flip-Flop / Quad D-Type Flip-Flop.

Fairchild Semiconductor
Fairchild Semiconductor
KTD1146

EPITAXIAL PLANAR NPN TRANSISTOR.

KEC
KEC


www.Datenblatt-PDF.com       |      2020       |      Kontakt     |      Suche