|
|
Número de pieza | CLAA201WA03 | |
Descripción | TFT LCD Module | |
Fabricantes | Chunghwa Picture Tubes | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de CLAA201WA03 (archivo pdf) en la parte inferior de esta página. Total 22 Páginas | ||
No Preview Available ! f
Chunghwa Picture Tubes, Ltd.
Technical Specification
To :
Date : 2005/10/28
CPT TFT-LCD
CLAA201WA03
wAwCCEwwPTEDwwBY:..jjxxllccdd..ccoomm
APPROVED BY
CHECKED BY
PREPARED BY
Prepared by : TFT-LCD Application Division
CHUNGHWA PICTUER TUBES, LTD.
Doc. No:
CLAA201WA03-PJM-V1
Issue Date: 2005/10/28
Free Datasheet http://www.datasheet4u.com/
1 page CPT
CHUNGHWA PICTURES TUBES, LTD.,
2. ABSOLUTE MAXIMUM RATINGS
The following are maximun values which, if exceeded, may cause faulty operation or damage to the
unit.
ITEM
SYMBOL MIN. MAX. UNIT Remark
Power Supply Voltage For LCD
VCC
0 6.5 V
--
Lamp Voltage
VL (680) (840) Vrms
--
Lamp Current
ILO 3 6.5 mArms *4). 7)
Lamp Frequency
FL (45) (75) kHz
--
Electrostatic Voltage
Operation Temperature (Surrounding)
VESDt
VESDc
Top
-200
-8000
0
200
8000
50
V
V
*5)
℃ *1). 2). 3). 6)
Storage Temperature
Tstg -20 60 ℃ *1). 2). 3)
Delayed Discharge Time
TD -- 1 sec *8)
[Note]
*1) The relative temperature and humidity range are as below sketch, 90%RHMax. (Ta≦40℃)
*2) The maximum wet bulb temperature ≦39℃(Ta>40℃) and without dewing.
*3) If you use the product in a environment which over the definition of temperature and humidity too
long to effect the result of eye-atching.
*4) Product life-time related to lamp current, pls operate the production follow statement at page 9
CN2, 4 (BACKLIGHT)
*5) The testing conditions are according to IEC 1000-4-2 specification:
VESDt:By using contact-mode to discharge each pin of the connector.
VESDc:By using contact-mode to discharge the module.
*6) If you operate the product in normal temperature range, the center surface of panel should be
under 60℃.
Humidity≦85%RH without condensation.
Relative Humidity ≦90% (Ta≦ 40℃)
wwwwww..jjxxllccdd..ccoommWet Bulb Temperature ≦39℃(Ta≧40℃)
*7) When lamp current over the definition of absolute maximun, product life-time will decay rapidly or
operate unusual. If lamp current is under 3.0mA, the lamp could be abnormal-starting.
If for special request testing,then the minimun value of current is 2mA.It is not to promise product
life-time and lighting in normally situation.
*8) Delayed discharge time test condition:
Starting lamp voltage = 1820Vrms
Before test TD, lamp should operate at least 1min. , and lamp current should follow typical lamp
current specification. To place panel at room temp. (25+/- 2℃) below for 24hr, and then to
measure TD with the same starting lamp voltage in dark room.
Relative humidity(%RH)
-20
CPT Confidential
90
(40,90)
Operating Range
80
Storage Range
60
(50,50.4)
40
(60,27.7)
20
5
0 20 40 50 60
Temperature(°C)
4/22 CLAA201WA03-TENTATIVE-
10
Free Datasheet http://www.datasheet4u.com/
5 Page CPT
CHUNGHWA PICTURES TUBES, LTD.,
CN3、CN4:BHSR-02VS-1 (JST)
<Mating connector : SM02B-BHSS-1-TB (JST)>
NO. PIN SYMBOL
DESCRIPTION
CN3
1
2
HV
LV
High Voltage Output for CCFL Lamp 3
Low Voltage Output for CCFL Lamp 3
CN4
1
2
HV
LV
High Voltage Output for CCFL Lamp 4
Low Voltage Output for CCFL Lamp 4
wwwwww..jjxxllccdd..ccoomm
CPT Confidential
10/22
CLAA201WA03-TENTATIVE-
10
Free Datasheet http://www.datasheet4u.com/
11 Page |
Páginas | Total 22 Páginas | |
PDF Descargar | [ Datasheet CLAA201WA03.PDF ] |
Número de pieza | Descripción | Fabricantes |
CLAA201WA01Y | TFT LCD Module | Chunghwa Picture Tubes |
CLAA201WA03 | TFT LCD Module | Chunghwa Picture Tubes |
CLAA201WA04 | Display Module | CHUNGHWA PICTURE TUBES |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |