Datenblatt-pdf.com


W583S40 Schematic ( PDF Datasheet ) - Winbond

Teilenummer W583S40
Beschreibung HIGH FIDELITY Power Speech
Hersteller Winbond
Logo Winbond Logo 




Gesamt 14 Seiten
W583S40 Datasheet, Funktion
www.DataSheet4U.com
Preliminary W583XXX
GENERAL DESCRIPTION
HIGH FIDELITY Power Speech TM
W583xxx are fabricated using the Winbond CMOS process. The W583xxx family is a new member of
the PowerSpeechsynthesizer series, with voice quality which is even better than before. The
W583xxx family has adopted the same architecture as the PowerSpeechsynthesizers while
replacing the 4-bit ADPCM algorithm with Winbonds new high fidelity voice synthesis algorithm to
produce better quality voice. W583xxx provides IR function, CPU interface, pad option for Ring or
Crystal oscillator and voice output in DAC current or PWM type.
According different voice duration, there are 11 bodies in W583xxx family, list them below.
PART NO. W583S10 W583S15 W583S20
Duration
10 sec
15 sec
20 sec
PART NO. W583S50 W583S60 W583S80
Duration
50 sec
60 sec
80 sec
Notes:
1. The voice duration is estimated by 6.4 KHz sampling rate.
2. W583S10 provides less I/O pins, and do not provide crystal oscillator.
W583S25
25 sec
W583S99
99 sec
W583S30
30 sec
W583M02
120 sec
W583S40
40 sec
FEATURES
Programmable speech synthesizer
New high fidelity synthesis algorithm
Wide operating voltage range: 2.4 - 5.5 Volts
Direct drive speaker by PWM output or Built-in 8-bit D/A converter
Supports CPU interface operation
IR interface for command Transmission and Receiving
Symbolic compiler supported
Instruction cycle 400 µS typically
Section control
Variable frequency: 4.8/6/8/12 KHz
LED: ON/OFF
Eight general-purpose registers R0-R7
Pad option for Ring or Crystal oscillator1
8 trigger inputs - with separate control of falling/rising edge trigger2
8 STOP outputs3
Number of interrupt vector / label up to 2,048
Notes:
1. W583S10 provide ring oscillator only.
2. Only 4 trigger pins in W583S10.
3. Only 5 STOP outputs in W583S10.
Publication Release Date: March 1999
- 1 - Revision A1






W583S40 Datasheet, Funktion
www.DataSheet4U.com
Preliminary W583XXX
2. MODE1 Register
BIT
7, 6, 1
5
DESCRIPTION
Reserved
LED Flash Type
4 LED1 Section
Control
3 LED2 Control
2 LED1 Volume
Control
0 IR Output Format
DEFINITION
1: Alternate
0: Synchronous
1: YES
0: NO
1: SECTION control
0: STPC control
1: Off
0: On
1: IR output carrier with duty cycle 75%
0: IR output without carrier
MODE1.5 is for LED flash type control. MODE1.4 is for LED1 section control ON/OFF. MODE1.3 is
for LED2 Section/STPC control. MODE1.2 is for LED1 volume control. MODE1.0 is for IR output with
or without carrier and this bit is useful only MODE0.5 is "1". For STPC control IR output (MODE0.5 is
0), the IR output always has 38 KHz carrier signal no matter what the setting of MODE1.0 is.
3. PAGE Register
BIT 7 6
PAGE -
-
54 3 2 1 0
- PG4 PG3 PG2 PG1 PG0
Bits 5-7 of PAGE register are reserved; bits 0-4 are used for page selection. The user must setup the
page mode configuration described in the Option Control Function section. Once the page mode is
decided, the working page is selected by the bits 0-4 of PAGE register. Hence, the user can execute
"LD PAGE, value" instruction to change the working page of the voice entry group. Not all of the bits
0-4 of PAGE register are used in different page mode; they are listed below.
PAGE MODE
PG4 PG3 PG2 PG1 PG0
1-page
×××××
8-page
××√√√
16-page
32-page
×√√√√
√√√√√
Where "×" means dont care and "" means must be set properly.
-6-

6 Page









W583S40 pdf, datenblatt
BONDING PAD DIAGRAM
(For W583S10 only)
www.DataSheet4U.com
Preliminary W583XXX
(0,0)
1
2
3
4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19
21
20
PAD NO.
1
2
3
4
5
6
7
8
9
10
11
PAD NAME
VDD
OSC
OSCO
TEST
RESET
TG1
TG2
TG3/IRIN
TG4
VSS
IROUT
PAD NO.
12
13
14
15
16
17
18
19
20
21
-
PAD NAME
LED1
STPA/BUSY
STPB
LED2/STPC
STPD
STPE
VSS1
VDD1
SPK-
AUD/SPK+
-
- 12 -

12 Page





SeitenGesamt 14 Seiten
PDF Download[ W583S40 Schematic.PDF ]

Link teilen




Besondere Datenblatt

TeilenummerBeschreibungHersteller
W583S40HIGH FIDELITY Power SpeechWinbond
Winbond

TeilenummerBeschreibungHersteller
CD40175BC

Hex D-Type Flip-Flop / Quad D-Type Flip-Flop.

Fairchild Semiconductor
Fairchild Semiconductor
KTD1146

EPITAXIAL PLANAR NPN TRANSISTOR.

KEC
KEC


www.Datenblatt-PDF.com       |      2020       |      Kontakt     |      Suche