Datenblatt-pdf.com


DMC-16202NY-LY-AGE Schematic ( PDF Datasheet ) - OPTREX CORPORATION

Teilenummer DMC-16202NY-LY-AGE
Beschreibung LCD Module
Hersteller OPTREX CORPORATION
Logo OPTREX CORPORATION Logo 




Gesamt 16 Seiten
DMC-16202NY-LY-AGE Datasheet, Funktion
www.DataSheet4U.com
LCD Module Specification
First Edition
Jul 9, 1999
Final Revision
*******
Type No. DMC16202NY-LY-AGE
Approved by
Checked by
Checked by
Prepared by
Production Div.
Quality Assurance Div.
Design Engineering Div.
Production Div.
Table of Contents
1. General Specifications .............................................................................2
2. Electrical Specifications...........................................................................3
3. Optical Specifications ..............................................................................6
4. I/O Terminal.............................................................................................8
5. Test..........................................................................................................10
6. Appearance Standards............................................................................11
7. Code System of Production Lot ..........................................................14
8. Type Number..........................................................................................14
9. Applying Precautions .............................................................................14
10. Precautions Relating Product Handling................................................15
11. Warranty..................................................................................................16
Revision History
Rev. Date
Page
Comment
DMC16202NY-LY-AGE (AZ) No.99-0204
DataSheet4 U .com
OPTREX CORPORATION
OPTREX
Page 1/16






DMC-16202NY-LY-AGE Datasheet, Funktion
www.DataSheet4U.com
3.Optical Specifications
3.1.LCD Driving Voltage
Parameter
Symbol
Conditions
Min. Typ. Max. Units
Recommended
Ta= 0
- - 5.0 V
LCD Driving Voltage
VCC-VEE
Ta=25
4.4 4.7 5.0
V
Note 1
Ta=50
4.2 - - V
Note 1 : Voltage (Applied actual waveform to LCD Module) for the best contrast. The range of
minimum and maximum shows tolerance of the operating voltage. The specified contrast ratio and
response time are not guaranteed over the entire range.
3.2.Optical Characteristics
Ta=25, 1/16 Duty, 1/4.5 Bias, VD=4.7V (Note 4), θ= 0 , φ=-゚
Parameter
Symbol
Conditions
Min. Typ. Max. Units
Contrast Ratio
Note 1
CR
θ= 0 , φ=-゚ - 10
Viewing Angle
Shown in 3.3
Response Rise Note 2
TON
- - 100 200 ms
Time Decay Note 3
TOFF
- - 200 300 ms
Note 1 : Contrast ratio is definded as follows.
CR = LOFF / LON
LON : Luminance of the ON segments
LOFF : Luminance of the OFF segments
Note 2 : The time that the luminance level reaches 90% of the saturation level from 0% when ON
signal is applied.
Note 3 : The time that the luminance level reaches 10% of the saturation level from 100% when OFF
signal is applied.
Note 4 : Definition of Driving Voltage VD
Assuming that the typical driving waveforms shown below are applied to the LCD Panel at
1/A Duty - 1/B Bias ( A : Duty Number, B : Bias Number ). Driving voltage VD is definded
as follows.
VD = (Vth1+Vth2) / 2
Vth1 : The voltage VO-P that should provide 50% of the saturation level in the luminance at
the segment which the ON signal is applied to.
Vth2 : The voltage VO-P that should provide 50% of the saturation level in the luminance at
the segment which the OFF signal is applied to.
VO-P
1 / ( fF×A )
ON SIGNAL
DMC16202NY-LY-AGE (AZ) No.99-0204
DataSheet4 U .com
1 / fF
( B-2 )×VO-P / B
OFF SIGNAL
OPTREX CORPORATION
OPTREX
Page 6/16

6 Page









DMC-16202NY-LY-AGE pdf, datenblatt
www.DataSheet4U.com
6.3.Standards
No. Parameter
Criteria
1 Black and
(1) Round Shape
White Spots,
Zone
Acceptable Number
Foreign Substances
Dimension (mm)
ABC
D 0.1
*
*
*
0.1 D 0.2
5
5
*
0.2 D 0.3
0
1
*
0.3 D
00*
D = ( Long + Short ) / 2 * : Disregard
(2) Line Shape
Zone
Acceptable Number
X(mm) Y(mm)
ABC
2.0L
1.0L
1.0L
0.02W
0.03W
0.04W
0.05W
0.05W
***
33*
12*
02*
In the same way (1)
X : Length Y : Width * : Disregard
Total defects shall not exceed 5.
2 Air Bubbles
(between glass
Zone
Acceptable Number
& polarizer)
Dimension (mm)
ABC
D 0.15
*
*
*
0.15D 0.3 2 3 *
0.3 D 0.5 1 2 *
0.5 D 1.0 0 1 *
* : Disregard
Total defects shall not exceed 3.
DMC16202NY-LY-AGE (AZ) No.99-0204
DataSheet4 U .com
OPTREX CORPORATION
OPTREX
Page 12/16

12 Page





SeitenGesamt 16 Seiten
PDF Download[ DMC-16202NY-LY-AGE Schematic.PDF ]

Link teilen




Besondere Datenblatt

TeilenummerBeschreibungHersteller
DMC-16202NY-LY-AGELCD ModuleOPTREX CORPORATION
OPTREX CORPORATION

TeilenummerBeschreibungHersteller
CD40175BC

Hex D-Type Flip-Flop / Quad D-Type Flip-Flop.

Fairchild Semiconductor
Fairchild Semiconductor
KTD1146

EPITAXIAL PLANAR NPN TRANSISTOR.

KEC
KEC


www.Datenblatt-PDF.com       |      2020       |      Kontakt     |      Suche