|
|
PDF CA3162A Data sheet ( Hoja de datos )
| Número de pieza | CA3162A | |
| Descripción | A/D Converters for 3-Digit Display | |
| Fabricantes | Intersil | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de CA3162A (archivo pdf) en la parte inferior de esta página. Total 7 Páginas | ||
|
No Preview Available !
CA3162, CA3162A
August 1997
A/D Converters for 3-Digit Display
Features
• Dual Slope A/D Conversion
• Multiplexed BCD Display
• Ultra Stable Internal Band Gap Voltage Reference
• Capable of Reading 99mV Below Ground with Single
Supply
• Differential Input
• Internal Timing - No External Clock Required
• Choice of Low Speed (4Hz) or High Speed (96Hz)
Conversion Rate
• “Hold” Inhibits Conversion but Maintains Delay
• Overrange Indication
- “EEE” for Reading Greater than +999mV, “-” for
Reading More Negative than -99mV When Used With
CA3161E
• Extended Temperature Range Version Available
Description
The CA3162E and CA3162AE are I2L monolithic A/D
converters that provide a 3 digit multiplexed BCD output.
They are used with the CA3161E BCD-to-Seven-Segment
Decoder/Driver and a minimum of external parts to imple-
ment a complete 3-digit display. The CA3162AE is identical
to the CA3162E except for an extended operating tempera-
ture range.
The CA3161E is described in the Display Drivers section of
this data book.
Ordering Information
TEMP.
PART NUMBER RANGE (oC)
PACKAGE
CA3162E
0 to 70 16 Ld PDIP
CA3162AE
-40 to 85 16 Ld PDIP
PKG.
NO.
E16.3
E16.3
Pinout
CA3162
(PDIP)
TOP VIEW
BCD
OUTPUTS
21 1
20 2
DIGIT
SELECT
OUTPUTS
NSD 3
MSD 4
LSD 5
HOLD/ 6
BYPASS
GND 7
ZERO ADJ 8
16 23
15 22
BCD
OUTPUTS
14 V+
13 GAIN ADJ
12 INTEGRATING
CAP
11 HIGH INPUT
10 LOW INPUT
9 ZERO ADJ
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Copyright © Intersil Corporation 1999
3-5
File Number 1080.2
1 page  
CA3162, CA3162A
CA3162E Liquid Crystal Display (LCD) Application
Figure 3 shows the CA3162E in a typical LCD application.
LCDs may be used in favor of LED displays in applications
requiring lower power dissipation, such as battery-operated
equipment, or when visibility in high-ambient-light conditions
is desired.
Multiplexing of LCD digits is not practical, since LCDs must
be driven by an AC signal and the average voltage across
each segment is zero. Three CD4056B liquid-crystal
decoder/drivers are therefore used. Each CD4056B contains
an input latch so that the BCD data for each digit may be
latched into the decoder using the inverted digit-select out-
puts of the CA3162E as strobes.
The capacitors on the outputs of inverters G3 and G4 filter
out the decode spikes on the MSD and NSD signals. The
capacitors and pull-up resistors connected to the MSD, NSD
and LSD outputs are there to shorten the digit drive signal
thereby providing proper timing for the CD4056B latches.
Inverters G1 and G2 are used as an astable multivibrator to
provide the AC drive to the LCD backplane. Inverters G3, G4
and G5 are the digit-select inverters and require pull-up
resistors to interface the open-collector outputs of the
CA3162E to CMOS logic. The BCD outputs of the CA3162E
may be connected directly to the corresponding CD4056B
inputs (using pull-up resistors). In this arrangement, the
CD4056B decodes the negative sign (-) as an “L” and the
positive overload indicator (E) as an “H”.
The circuit as shown in Figure 3 using G7, G8 and G9 will
decode the negative sign (-) as a negative sign (-), and the
positive overload indicator (E) as “H”.
0.047µF
G3
0.047µF
+5V
ZERO
50kΩ
“HOLD”
VIN+
6x
10kΩ
0.27µF
8 14 12 4
3
95
16
CA3162E 15
1
11 2
MSD
NSD
LSD
23
22
21
20
VIN- 10 13
GAIN
7 4x
100kΩ
10kΩ
0.047
µF
0.047µF
G4
0.047
µF
G5
+5V
G1 - G6: CD4049UB
HEX INVERTER
G7, G8, G9: CD4023B
TRIPLE 3 INPUT NAND GATE
G7
G8
G9
FIGURE 3. TYPICAL LCD APPLICATION
+5V
1 16
6
4
CD4056B
2
3
57
8
TO MSD
OF LCD
+5V
1 16
6
4
CD4056B
2
3
57
8
TO NSD
OF LCD
+5V
1 16
6
4
CD4056B
2
3
57
8
TO LSD
OF LCD
TO LCD
BACKPLANE
15kΩ
100kΩ
0.63µF
3-9
5 Page | ||
| Páginas | Total 7 Páginas | |
| PDF Descargar | [ Datasheet CA3162A.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| CA3162 | A/D Converters for 3-Digit Display | Intersil |
| CA3162A | A/D Converters for 3-Digit Display | Intersil |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |