|
|
Teilenummer | RA13H8891MB |
|
Beschreibung | 3 Stage Amp | |
Hersteller | Mitsubishi Electric | |
Logo | ||
Gesamt 8 Seiten www.DataSheet4U.com
ELECTROSTATIC SENSITIVE DEVICE
OBSERVE HANDLING PRECAUTIONS
MITSUBISHI RF MOSFET MODULE
RA13H8891MB
RoHS Compliance , 880-915MHz 13W 12.5V, 3 Stage Amp. For MOBILE RADIO
DESCRIPTION
The RA13H8891MB is a 13-watt RF MOSFET Amplifier
Module for 12.5-volt mobile radios that operate in the 880- to
915-MHz range.
The battery can be connected directly to the drain of the
enhancement-mode MOSFET transistors. Without the gate
voltage (VGG=0V), only a small leakage current flows into the
drain and the RF input signal attenuates up to 60 dB. The output
power and drain current increase as the gate voltage increases.
With a gate voltage around 4V (minimum), output power and
drain current increases substantially. The nominal output power
becomes available at 4.5V (typical) and 5V (maximum). At
VGG=5V, the typical gate current is 1 mA.
This module is designed for non-linear FM modulation, but may
also be used for linear modulation by setting the drain quiescent
current with the gate voltage and controlling the output power
with the input power.
FEATURES
• Enhancement-Mode MOSFET Transistors
(IDD≅0 @ VDD=12.5V, VGG=0V)
• Pout>13W, ηT>35% @ VDD=12.5V, VGG=5V, Pin=1mW
• Broadband Frequency Range: 880-915MHz
• Low-Power Control Current IGG=1mA (typ) at VGG=5V
• Module Size: 60.5 x 14 x 6.4 mm
• Linear operation is possible by setting the quiescent drain
current with the gate voltage and controlling the output power
with the input power
BLOCK DIAGRAM
2
1
3
4
5
1 RF Input (Pin)
2 Gate Voltage (VGG), Power Control
3 Drain Voltage (VDD), Battery
4 RF Output (Pout)
5 RF Ground (Case)
PACKAGE CODE: H11S
RoHS COMPLIANCE
• RA13H8891MB-101 is a RoHS compliant products.
• RoHS compliance is Indicate by the letter “G” after the lot Marking.
• This product include the lead in the Glass of electronic parts and the
lead in electronic Ceramic parts.
How ever ,it applicable to the following exceptions of RoHS Directions.
1.Lead in the Glass of a cathode-ray tube, electronic parts, and
fluorescent tubes.
2.Lead in electronic Ceramic parts.
ORDERING INFORMATION:
ORDER NUMBER
RA13H8891MB-101
SUPPLY FORM
Antistatic tray,
20 modules/tray
RA13H8891MB
MITSUBISHI ELECTRIC
1/8
24 Jan 2006
ELECTROSTATIC SENSITIVE DEVICE
OBSERVE HANDLING PRECAUTIONS
MITSUBISHI RF POWER MODULE
RoHS COMPLIANCE RA13H8891MB
TEST BLOCK DIAGRAM
Power
Meter
DUT
5
12
34
Spectrum
Analyzer
Signal
Pre- Directional
Generator Attenuator amplifier Attenuator
Coupler
ZG=50Ω
C1
C2
ZL=50Ω
Directional
Power
Coupler
Attenuator Meter
C1, C2: 4700pF, 22uF in parallel
-+
DC Power
Supply VGG
+-
DC Power
Supply VDD
1 RF Input (Pin)
2 Gate Voltage (VGG)
3 Drain Voltage (VDD)
4 RF Output (Pout)
5 RF Ground (Case)
EQUIVALENT CIRCUIT
2
3
1
RA13H8891MB
MITSUBISHI ELECTRIC
6/8
4
5
24 Jan 2006
6 Page | ||
Seiten | Gesamt 8 Seiten | |
PDF Download | [ RA13H8891MB Schematic.PDF ] |
Teilenummer | Beschreibung | Hersteller |
RA13H8891MA | 2 Stage Amp | Mitsubishi Electric |
RA13H8891MB | 3 Stage Amp | Mitsubishi Electric |
Teilenummer | Beschreibung | Hersteller |
CD40175BC | Hex D-Type Flip-Flop / Quad D-Type Flip-Flop. |
Fairchild Semiconductor |
KTD1146 | EPITAXIAL PLANAR NPN TRANSISTOR. |
KEC |
www.Datenblatt-PDF.com | 2020 | Kontakt | Suche |