|
|
PDF ECP200G Data sheet ( Hoja de datos )
| Número de pieza | ECP200G | |
| Descripción | High Linearity InGaP HBT Amplifier | |
| Fabricantes | WJ Communication | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de ECP200G (archivo pdf) en la parte inferior de esta página. Total 9 Páginas | ||
|
No Preview Available !
www.DataSheet4U.com
AH312 / ECP200G
2 Watt, High Linearity InGaP HBT Amplifier Product Information
Product Features
Product Description
Functional Diagram
• 400 – 2300 MHz
• +33 dBm P1dB
• +51 dBm Output IP3
• 18 dB Gain @ 900 MHz
• 11 dB Gain @ 1960 MHz
• Single Positive Supply (+5V)
• Lead-free/green/RoHS-compliant
SOIC-8 SMT Pkg.
Applications
• Final stage amplifiers for Repeaters
• Mobile Infrastructure
• Defense / Homeland Security
The AH312 / ECP200 is a high dynamic range driver
amplifier in a low-cost surface mount package. The
InGaP/GaAs HBT is able to achieve high performance for
various narrowband-tuned application circuits with up to
+49 dBm OIP3 and +33 dBm of compressed 1dB power. It
is housed in a lead-free/green/RoHS-compliant SOIC-8
package. All devices are 100% RF and DC tested.
The AH312 / ECP200 is targeted for use as a driver
amplifier in wireless infrastructure where high linearity and
medium power is required. An internal active bias allows
the AH312 to maintain high linearity over temperature and
operate directly off a single +5V supply. This combination
makes the device an excellent candidate for transceiver line
cards in current and next generation multi-carrier 3G base
stations.
18
27
36
45
Function
Vref
Input
Output
Vbias
GND
N/C or GND
Pin No.
1
3
6, 7
8
Backside Paddle
2, 4, 5
Specifications (1)
Parameter
Units
Operational Bandwidth
MHz
Test Frequency
MHz
Gain dB
Input R.L.
dB
Output R.L.
dB
Output P1dB
Output IP3 (2)
dBm
dBm
IS-95A Channel Power
@ -45 dBc ACPR, 1960 MHz
W-CDMA Channel Power
@ -45 dBc ACLR, 2140 MHz
Noise Figure
Operating Current Range, Icc (3)
dBm
dBm
dB
mA
Device Voltage, Vcc
V
Min
400
9
+32
+47
700
Typ
2140
10
20
6.8
+33.2
+48
+27.5
+25.3
7.7
800
+5
Max
2300
900
1. Test conditions unless otherwise noted: 25ºC, +5V Vsupply, 2140 MHz, in tuned application circuit.
2. 3OIP measured with two tones at an output power of +17 dBm/tone separated by 1 MHz. The
suppression on the largest IM3 product is used to calculate the 3OIP using a 2:1 rule.
3. This corresponds to the quiescent current or operating current under small-signal conditions into
pins 6, 7, and 8. It is expected that the current can increase by an additional 200 mA at P1dB. Pin
1 is used as a reference voltage for the internal biasing circuitry. It is expected that Pin 1 will pull
22mA of current when used with a series bias resistor of R1=15Ω. (ie. total device current
typically will be 822 mA.)
Typical Performance (4)
Parameter
Frequency
S21 – Gain
S11 – Input R.L.
S22 – Output R.L.
Output P1dB
Output IP3
IS-95A Channel Power
@ -45 dBc ACPR
W-CDMA Channel Power
@ -45 dBc ACLR
Noise Figure
Device Bias (3)
Units
MHz
dB
dB
dB
dBm
dBm
dBm
dBm
dB
Typical
900 1960 2140
18 11 10
-18 -19 -20
-11 -6.8 -6.8
+33 +33.4 +33.2
+49 +51 +48
+27 +27.5
+25.3
8.0 7.3 7.7
+5 V @ 800 mA
4. Typical parameters reflect performance in a tuned application circuit at +25° C.
Absolute Maximum Rating
Parameter
Operating Case Temperature
Storage Temperature
RF Input Power (continuous)
Device Voltage
Device Current
Device Power
Junction Temperature
Rating
-40 to +85 °C
-65 to +150 °C
+28 dBm
+8 V
1400 mA
8W
+250 °C
Operation of this device above any of these parameters may cause permanent damage.
Ordering Information
Part No.
Description
AH312-S8*
ECP200G*
AH312-S8G
AH312-S8PCB900
2 Watt, High Linearity InGaP HBT Amplifier
(lead-tin SOIC-8 Pkg)
2 Watt, High Linearity InGaP HBT Amplifier
(lead-tin SOIC-8 Pkg)
2 Watt, High Linearity InGaP HBT Amplifier
(lead-free/green/RoHS-compliant SOIC-8 Pkg)
900 MHz Evaluation Board
AH312-S8PCB1960 1960 MHz Evaluation Board
AH312-S8PCB2140 2140 MHz Evaluation Board
* This package is being phased out in favor of the green package type which is backwards compatible for
existing designs. Refer to Product Change Notification WJPCN06MAY05TC1 on the WJ website.
Specifications and information are subject to change without notice.
WJ Communications, Inc • Phone 1-800-WJ1-4401 • FAX: 408-577-6621 • e-mail: [email protected] • Web site: www.wj.com
Page 1 of 9 June 2005
1 page  
AH312 / ECP200G
2 Watt, High Linearity InGaP HBT Amplifier Product Information
2140 MHz Application Circuit (AH312-S8PCB2140)
Typical RF Performance at 25°C
Frequency
2140 MHz
S21 – Gain
10 dB
S11 – Input Return Loss
-20 dB
S22 – Output Return Loss
-6.8 dB
Output P1dB
+33.2 dBm
Output IP3
(+17 dBm / tone, 1 MHz spacing)
W-CDMA Channel Power
(@ -45 dBc ACLR)
+48 dBm
+25.3 dBm
Noise Figure
7.7 dB
Device / Supply Voltage
+5 V
Quiescent Current (1)
800 mA
1. This corresponds to the quiescent current or operating current under
small-signal conditions into pins 6, 7, and 8.
S21 vs. Frequency
12
11
10
9
8
+25°C -40°C +85°C
7
2110 2120 2130 2140 2150 2160 2170
Frequency (MHz)
NoiseFigurevs. Frequency
10
S11 vs. Frequency
0
+25°C -40°C +85°C
-5
-10
-15
-20
-25
-30
2110 2120 2130 2140 2150 2160 2170
Frequency (MHz)
P1dBvs. Frequency
Circuit boardsareoptimized at 2140 MHz
36
S22 vs. Frequency
0
-5
-10
-15
+25°C -40°C +85°C
-20
2110 2120 2130 2140 2150 2160 2170
Frequency (MHz)
ACPRvs. Channel Power
3GPPW-CDMA, Test Model 1+64 DPCH, ±5 MHz offset, 2140 MHz
-35
8 34 -40
6 32 -45
4 30 -50
2
-40°C +25°C +85°C
0
2110 2120 2130 2140 2150 2160 2170
Frequency (MHz)
OIP3 vs. Frequency
55 +25° C, +17 dBm/tone
28
-40°C +25°C +85°C
26
2110 2120 2130 2140 2150 2160 2170
Frequency (MHz)
OIP3vs. Temperature
55 freq. = 2140MHz, 2141MHz, +17dBm/tone
-55
-60
22
55
-40 C +25C +85C
23 24 25 26
Output Channel Power (dBm)
OIP3vs. Output Power
freq. =2140MHz, 2141 MHz, +25° C
27
50 50 50
45 45 45
40 40 40
35
2110 2120 2130 2140 2150 2160 2170
Frequency (MHz)
35
-40
-15 10 35
Temperature (°C)
60
35
85 12
14 16 18 20
Output Power (dBm)
22
Specifications and information are subject to change without notice.
WJ Communications, Inc • Phone 1-800-WJ1-4401 • FAX: 408-577-6621 • e-mail: [email protected] • Web site: www.wj.com
Page 5 of 9 June 2005
5 Page | ||
| Páginas | Total 9 Páginas | |
| PDF Descargar | [ Datasheet ECP200G.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| ECP200 | 2.0 WATT POWER AMPLIFIER |  EIC discrete Semiconductors |
| ECP200D | High Linearity InGaP HBT Amplifier | WJ Communication |
| ECP200G | High Linearity InGaP HBT Amplifier | WJ Communication |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |