Datenblatt-pdf.com


GS3019 Schematic ( PDF Datasheet ) - Gennum Corporation

Teilenummer GS3019
Beschreibung Hybrid
Hersteller Gennum Corporation
Logo Gennum Corporation Logo 




Gesamt 5 Seiten
GS3019 Datasheet, Funktion
www.DataSheet4U.com
GS3019 Hybrid
with LS509 Amplifier
GS3019 - HYB DATA SHEET
FEATURES
• Gennum’s LS509 3 stage amplifier
• independent preamp can be used as telecoil
preamplifier
• four “must use” capacitors mounted on hybrid
• choice of 5 settings for optimal transducer
current
• easy assembly and high reliability
STANDARD PACKAGING
This hybrid is very similar to Gennum's 3010 with the
exception that capacitors C2 and C3 on the GS3019 have
been increased in value to extend the frequency response
of the system. C2 and the output impedance of the
microphone form a high pass filter with a corner frequency
of approximately 180 Hz. The hybrid allows for easy
adjustment of this corner frequency via the addition of
components to its many additional solder pads. Likewise,
R3 and C3 form a high pass filter with a corner frequency
of 130 Hz. Altering this frequency is easily accomplished
by adding additional capacitance between pads 12 and 2
on the hybrid.
• Hybrid Typical Dimensions
0.276 in x 0.101 in x 0.094 in
(7.01 mm x 2.57 mm x 2.39 mm)
DESCRIPTION
The hybrid consists of Gennum's LS509 class A amplifier,
four capacitors, and two selectable bias resistors. This
hybrid is very similar to Gennum's 3010 with the exception
that capacitors C2 and C3 on the GS3019 have been
increased in value to extend the frequency response of
the system.
Stage C of the LS509 is a class A current drive output. There
is a fixed reference voltage of typically 29 mV at pin 2 of the
chip (pad 5 of the hybrid). The current that flows in the
receiver is the ratio of this 29 mV reference voltage to the
resistance seen from pin 2 to ground. R1 and R2 have been
included on the GS3019 to allow for easy adjustment of the
current for the most commonly used receivers.
The system also has the capability of MPO (Maximum Power
Output) control. This is provided by the Schottky diodes on
the LS509 die. To make use of the diodes in the system, a
potentiometer must be added from pads 7 to 9 on the hybrid.
VB
8
VCC
8
VMIC 15
C1
7
4k
4µ7
GS3019
C4
9 0µ1
7 MPO
C2
IN 16
220n
-A
6
21k
-B -C
10
9 OUT
LS509 - DIE 5
4
125 RE
31
2
MGND 1
R1 R2
58 98
R3 C3
5k6 220n
14
3 12 2 13
4
A IN
A OUT A OUTR B INC B IN
B OUT
All resistors in ohms, all capacitors in farads unless otherwise stated.
6 17 11 18 10 5
GND GND1 R1 GND2 R2 R3
Revision Date: May 1998
FUNCTIONAL BLOCK DIAGRAM
Document No. 521 - 04 - 02
GENNUM CORPORATION P.O. Box 489, Stn. A, Burlington, Ontario, Canada L7R 3Y3 tel. +1 (905) 632-2996
Web Site: www.gennum.com E-mail: [email protected]





SeitenGesamt 5 Seiten
PDF Download[ GS3019 Schematic.PDF ]

Link teilen




Besondere Datenblatt

TeilenummerBeschreibungHersteller
GS3010HybridGennum
Gennum
GS3011DynamEQ I Dynamic EqualizerGennum
Gennum
GS3013Linear Class H Current Manager HybridGennum
Gennum
GS3015Preamp HybridGennum Corporation
Gennum Corporation
GS3018N-CHANNEL MOSFETGTM
GTM

TeilenummerBeschreibungHersteller
CD40175BC

Hex D-Type Flip-Flop / Quad D-Type Flip-Flop.

Fairchild Semiconductor
Fairchild Semiconductor
KTD1146

EPITAXIAL PLANAR NPN TRANSISTOR.

KEC
KEC


www.Datenblatt-PDF.com       |      2020       |      Kontakt     |      Suche