Datenblatt-pdf.com


ADG3300 Schematic ( PDF Datasheet ) - Analog Devices

Teilenummer ADG3300
Beschreibung 8-Channel Bidirectional Logic Level Translator
Hersteller Analog Devices
Logo Analog Devices Logo 




Gesamt 20 Seiten
ADG3300 Datasheet, Funktion
www.DataSheet4U.com
Low Voltage 1.15 V to 5.5 V, 8-Channel
Bidirectional Logic Level Translator
ADG3300
FEATURES
Bidirectional level translation
Operates from 1.15 V to 5.5 V
Low quiescent current <1 µA
No direction pin
APPLICATIONS
Low voltage ASIC level translation
Smart card readers
Cell phones and cell phone cradles
Portable communications devices
Telecommunications equipment
Network switches and routers
Storage systems (SAN/NAS)
Computing/server applications
GPS
Portable POS systems
Low cost serial interfaces
GENERAL DESCRIPTION
The ADG3300 is a bidirectional logic level translator that con-
tains eight bidirectional channels. It can be used in multivoltage
digital system applications such as data transfer between a low
voltage DSP/controller and a higher voltage device. The internal
architecture allows the device to perform bidirectional logic
level translation without an additional signal to set the direction
of the translation.
The voltage applied to VCCA sets the logic levels on the A side of
the device, while VCCY sets the levels on the Y side. For proper
operation, VCCA must always be less than VCCY. The VCCA-com-
patible logic signals applied to the A side of the device appear as
VCCY-compatible levels on the Y side. Similarly, VCCY-compatible
logic levels applied to the Y side of the device appear as VCCA-
compatible logic levels on the A side.
The enable pin provides three-state operation of the Y side pins.
When the enable pin (EN) is pulled low, the A1 to A8 pins are
FUNCTIONAL BLOCK DIAGRAM
VCCA
VCCY
A1 Y1
A2 Y2
A3 Y3
A4 Y4
A5 Y5
A6 Y6
A7 Y7
A8 Y8
EN
GND
Figure 1.
internally pulled down by 6 kΩ resistors, while the Y terminals
are in the high impedance state. The EN pin is referred to VCCA
supply voltage and driven high for normal operation.
The ADG3300 is available in a compact 20-lead TSSOP package,
and it is guaranteed to operate over the 1.15 V to 5.5 V supply
voltage range and extended −40°C to +85°C temperature range.
PRODUCT HIGHLIGHTS
1. Bidirectional level translation.
2. Fully guaranteed over the 1.15 V to 5.5 V supply range.
3. No direction pin.
4. 20-lead TSSOP package.
Rev. 0
Information furnished by Analog Devices is believed to be accurate and reliable.
However, no responsibility is assumed by Analog Devices for its use, nor for any
infringements of patents or other rights of third parties that may result from its use.
Specifications subject to change without notice. No license is granted by implication
or otherwise under any patent or patent rights of Analog Devices. Trademarks and
registered trademarks are the property of their respective owners.
DataSheet4 U .com
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
www.analog.com
Fax: 781.461.3113 © 2005 Analog Devices, Inc. All rights reserved.






ADG3300 Datasheet, Funktion
www.DataSheet4U.com
ADG3300
ABSOLUTE MAXIMUM RATINGS
TA = 25°C, unless otherwise noted.
Table 2.
Parameter
VCCA to GND
VCCY to GND
Digtal Inputs (A)
Digtal Inputs (Y)
EN to GND
Operating Temperature Range
Industrial (B Version)
Storage Temperature Range
Junction Temperature
θJA Thermal Impedance (4-Layer Board)
20-Lead TSSOP
Lead Temperature, Soldering (10 sec)
IR Reflow, Peak Temperature (<20 sec)
Rating
−0.3 V to +7 V
VCCA to +7 V
−0.3 V to (VCCA + 0.3 V)
−0.3 V to (VCCY + 0.3 V)
−0.3 V to +7 V
−40°C to +85°C
−65°C to +150°C
150°C
78°C/W
300°C
260°C
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those listed in the operational sections
of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability. Only one absolute maximum rating may be
applied at any one time.
ESD CAUTION
ESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000 V readily accumulate on the
human body and test equipment and can discharge without detection. Although this product features
proprietary ESD protection circuitry, permanent damage may occur on devices subjected to high energy
electrostatic discharges. Therefore, proper ESD precautions are recommended to avoid performance
degradation or loss of functionality.
DataSheet4 U .com
Rev. 0 | Page 6 of 20

6 Page









ADG3300 pdf, datenblatt
www.DataSheet4U.com
ADG3300
TEST CIRCUITS
0.1µF
EN
VCCA
A
K1
IOH IOL
ADG3300
GND
VCCY
0.1µF
Y
K2
Figure 27. VOH/VOL Voltages at Pin A
EN
VCCA
0.1µF
K2 A
ADG3300
GND
VCCY
0.1µF
Y
K1
IOH IOL
Figure 28. VOH/VOL Voltages at Pin Y
0.1µF
EN
VCCA
A
ADG3300
VCCY
0.1µF
YK
A
GND
Figure 29. Three-State Leakage Current at Pin Y
0.1µF
A
K
VCCA
A
EN
ADG3300
GND
VCCY
0.1µF
Y
Figure 30. EN Pin Leakage Current
EN
VCCA
ADG3300
VCCY
AY
GND
CAPACITANCE
METER
Figure 31.Capacitance at Pin Y
DataSheet4 U .com
Rev. 0 | Page 12 of 20

12 Page





SeitenGesamt 20 Seiten
PDF Download[ ADG3300 Schematic.PDF ]

Link teilen




Besondere Datenblatt

TeilenummerBeschreibungHersteller
ADG33008-Channel Bidirectional Logic Level TranslatorAnalog Devices
Analog Devices
ADG3301Single-Channel Bidirectional Logic Level TranslatorAnalog Devices
Analog Devices
ADG3304Bidirectional Logic Level TranslatorAnalog Devices
Analog Devices
ADG33088-Channel Bidirectional Logic Level TranslatorsAnalog Devices
Analog Devices
ADG3308-18-Channel Bidirectional Logic Level TranslatorsAnalog Devices
Analog Devices

TeilenummerBeschreibungHersteller
CD40175BC

Hex D-Type Flip-Flop / Quad D-Type Flip-Flop.

Fairchild Semiconductor
Fairchild Semiconductor
KTD1146

EPITAXIAL PLANAR NPN TRANSISTOR.

KEC
KEC


www.Datenblatt-PDF.com       |      2020       |      Kontakt     |      Suche