|
|
PDF LM151X3-B3 Data sheet ( Hoja de datos )
| Número de pieza | LM151X3-B3 | |
| Descripción | TFT LCD | |
| Fabricantes | Philips | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de LM151X3-B3 (archivo pdf) en la parte inferior de esta página. Total 22 Páginas | ||
|
No Preview Available !
www.DataSheet4U.com
TITLE: LM151X3-B3PL LIQUID CRYSTAL DISPLAY
SPECIFICATIONS
LM151X3-B3PL REV. 1.0 PAGE 1 OF 22
DATA DISPLAY AG
LM151X3-B3 PANELLINK
15.1“ XGA TFT LCD
PRELIMINARY
SPECIFICATION
The information given in this document is carefully checked and believed to be reliable. Data Display reserves the
right to make changes in product or specification at any time and without further notice. Data Display products are
not intended for use in systems in which failures of product could result in personal injury. All mentioned trademarks
are registered trademarks of their owner.
LG.Philips LCD: Rev. 1.1, June 27, 2000
DATA DISPLAY AG
Industriestrasse 1
D-82110 Germering
MAY 2001
http://www.datadisplay.de
Tel.: +49-89-894450-0
Fax: +49-89-894450-90
1 page  
www.DataSheet4U.com
SPECIFICATIONS
TITLE: LM151X3-B3PL LIQUID CRYSTAL DISPLAY
LM151X3-B3PL REV. 1.0 PAGE 5 OF 22
possible from the horizontal synchronous frequency and from its
harmonics in order to prevent interference.
Notes 5: The brightness of the lamp after being lighted for 5 minutes is definded as
100%. This is the time required for the brightness of the center of the lamp to be
not less than 95%.
Notes 6: The lamp power consumption shown above does not include loss of
external inverter.
Notes 7: The life time is determined as the time at which brightness of lamp is 50%
compared to that of initial value at the typical lamp current on condition of
continuous operating at 25 ±2°.
3.2 Interface Connections
This LCM has four interface connections, a 20 pin connector and a 14 pin connector
are used for the module electronics and, two three pin connectors are used for the
integral backlight system.
The electronics interface connector is a model DF19K-20P-1H (20 Pin connector)
and the other model DF19L-14P-1H (14 Pin connector) manufactured by Hirose. The
pin configuration for the connector is shown in the table below. (LCD Connector:
DF19K-20P-1H and DF19L-14P-1H, Mating Connector: DF19G-20S-1C and DF19G-
14S-1C.)
Table 3 MODULE CONNECTOR PIN CONFIGURATION
Pin Symbol
I/O
Description
Pin Symbol I/O
Description
1
GND
INPUT
Ground
1 GND INPUT
Ground
2
GND
INPUT
Ground
2 Vsync. OUTPUT
Vsync.
3 Rx2+ INPUT Plus Red TMDS signal 3 Hsync. OUTPUT
Hsync.
4
Rx2-
INPUT Minus Red TMDS signal 4 GND INPUT
Ground
5
GND
INPUT
Ground
5
NC
6 Rx1+ INPUT Plus Green TMDS signal 6
NC
7
Rx1-
INPUT Minus Green TMDS signal 7
NC
8
GND
INPUT
Ground
8 GND INPUT
Ground
9 Rx0+ INPUT Plus Blue TMDS signal 9 VCC INPUT Logic Power +3.3V
10 Rx0- INPUT Minus Blue TMDS signal 10 VCC INPUT Logic Power +3.3V
11 GND INPUT
Ground
11 VDD INPUT Analog Power +5V
12 RxC+ INPUT
Plus Main clock
12 VDD INPUT Analog Power +5V
13 RxC- INPUT
Minus Main clock
13 VDD INPUT Analog Power +5V
14 GND INPUT
Ground
14 GND INPUT
Ground
15 NC
16 NC
17 NC
18 NC
19 NC
20 GND INPUT
Ground
DATA DISPLAY AG
Industriestrasse 1
D-82110 Germering
MAY 2001
http://www.datadisplay.de
Tel.: +49-89-894450-0
Fax: +49-89-894450-90
5 Page 
www.DataSheet4U.com
TITLE: LM151X3-B3PL LIQUID CRYSTAL DISPLAY
3.7 Vdd Dip Condition
SPECIFICATIONS
LM151X3-B3PL REV. 1.0 PAGE 11 OF 22
Vdd
td
1) 3.5V = Vdd ? 4.5V
td = 20ms
2) Vdd ? 5.5V
Vdd-dip conditions should also follow the Power Up/Down conditions for
supply voltage
Note:
This phenomenon is caused by row driver IC initialization after power on
(1 vertical period) .
DATA DISPLAY AG
Industriestrasse 1
D-82110 Germering
MAY 2001
http://www.datadisplay.de
Tel.: +49-89-894450-0
Fax: +49-89-894450-90
11 Page | ||
| Páginas | Total 22 Páginas | |
| PDF Descargar | [ Datasheet LM151X3-B3.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| LM151X3-B3 | TFT LCD | Philips |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |