Datenblatt-pdf.com


P80C652FFAA Schematic ( PDF Datasheet ) - NXP Semiconductors

Teilenummer P80C652FFAA
Beschreibung CMOS single-chip 8-bit microcontrollers
Hersteller NXP Semiconductors
Logo NXP Semiconductors Logo 




Gesamt 25 Seiten
P80C652FFAA Datasheet, Funktion
INTEGRATED CIRCUITS
80C652/83C652
CMOS single-chip 8-bit microcontrollers
Product specification
IC20 Data Handbook
1996 Aug 15
Philips
Semiconductors






P80C652FFAA Datasheet, Funktion
Phlips Semiconductors
CMOS single-chip 8-bit microcontrollers
BLOCK DIAGRAM
FREQUENCY
REFERENCE
XTAL2 XTAL1
OSCILLATOR
AND
TIMING
PROGRAM
MEMORY
(8K x 8 ROM)
DATA
MEMORY
(256 x 8 RAM)
COUNTERS
T0 T1
TWO 16-BIT
TIMER/EVENT
COUNTERS
Product specification
80C652/83C652
CPU
I2C SERIAL I/O
SDA SHARED
WITH
SCL PORT 1
INTERNAL
INTERRUPTS
64K BYTE BUS
EXPANSION
CONTRTOL
PROGRAMMABLE I/O
PROG SERIAL PORT
FULL DUPLEX UART
SYNCHRONOUS SHIFT
INT0
INT1
EXTERNAL
INTERRUPTS
CONTROL
PARALLEL PORTS,
ADDRESS/DATA BUS
AND I/O PINS
SERIAL IN SERIAL OUT
SHARED WITH
PORT 3
1996 Aug 15
6

6 Page









P80C652FFAA pdf, datenblatt
Phlips Semiconductors
CMOS single-chip 8-bit microcontrollers
Product specification
80C652/83C652
NOTES FOR DC ELECTRICAL CHARACTERISTICS:
1. See Figures 9 through 11 for IDD test conditions.
2. The operating supply current is measured with all output pins disconnected; XTAL1 driven with tr = tf = 5ns;
VIL = VSS + 0.5V; VIH = VDD –0.5V; XTAL2 not connected; EA = RST = Port 0 = P1.6 = P1.7 = VDD. See Figure 9.
3. The idle mode supply current is measured with all output pins disconnected; XTAL1 driven with tr = tf = 5ns; VIL = VSS + 0.5V;
VIH = VDD –0.5V; XTAL2 not connected; Port 0 = P1.6 = P1.7 = VDD; EA = RST = VSS. See Figure 10.
4. The power-down current is measured with all output pins disconnected; XTAL2 not connected; Port 0 = P1.6 = P1.7 = VDD;
EA = RST = VSS. See Figure 11.
5. 2V VPD VDDmax.
6. The input threshold voltage of P1.6 and P1.7 (SIO1) meets the I2C specification, so an input voltage below 0.3VDD will be recognized as a
logic 0 while an input voltage above 0.7VDD will be recognized as a logic 1.
7. Pins of ports 1 , 2, and 3 source a transition current when they are being externally driven from 1 to 0. The transition current reaches its
maximum value when VIN is approximately 2V.
8. Capacitive loading on ports 0 and 2 may cause spurious noise to be superimposed on the VOLs of ALE and ports 1 and 3. The noise is due
to external bus capacitance discharging into the port 0 and port 2 pins when these pins make 1-to-0 transitions during bus operations. In the
worst cases (capacitive loading > 100pF), the noise pulse on the ALE pin may exceed 0.8V. In such cases, it may be desirable to qualify
ALE with a Schmitt Trigger, or use an address latch with a Schmitt Trigger STROBE input.
9. Under steady state (non-transient) conditions, IOL must be externally limited as follows: Maximum IOL = 10mA per port pin; Maximum
IOL = 26mA total for Port 0; Maximum IOL = 15mA total for Ports 1, 2, and 3; Maximum IOL = 71mA total for all output pins. If IOL exceeds the
test conditions, VOL may exceed the related specification. Pins are not guaranteed to sink current greater than the listed test conditions.
10. Capacitive loading on ports 0 and 2 may cause the VOH on ALE and PSEN to momentarily fall below the 0.9VDD specification when the
address bits are stabilizing.
11. IDDMAX for other frequencies can be derived from Figure 1, where FREQ is the external oscillator frequency in MHz. IDDMAX is given in mA.
40
IDD
(mA)
30
20
50
IDD
(mA)
40
30
(1)
20
(1)
10
10
(2)
(2)
0
0 4 8 12 16
fXTAL1 (MHz)
(1) MAXIMUM OPERATING MODE: VDD = VDDmax
(2) MAXIMUM IDLE MODE: VDD = VDDmax
These values are valid within the specified
frequency range.
0
04
8 12
(1) MAXIMUM OPERATING MODE: VDD = VDDmax
(2) MAXIMUM IDLE MODE: VDD = VDDmax
These values are valid within the specified
frequency range.
16 24
fXTAL1 (MHz)
Figure 1. IDD vs. Frequency
1996 Aug 15
12

12 Page





SeitenGesamt 25 Seiten
PDF Download[ P80C652FFAA Schematic.PDF ]

Link teilen




Besondere Datenblatt

TeilenummerBeschreibungHersteller
P80C652FFACMOS single-chip 8-bit microcontrollersNXP Semiconductors
NXP Semiconductors
P80C652FFACMOS single-chip 8-bit microcontrollerNXP Semiconductors
NXP Semiconductors
P80C652FFAACMOS single-chip 8-bit microcontrollersNXP Semiconductors
NXP Semiconductors

TeilenummerBeschreibungHersteller
CD40175BC

Hex D-Type Flip-Flop / Quad D-Type Flip-Flop.

Fairchild Semiconductor
Fairchild Semiconductor
KTD1146

EPITAXIAL PLANAR NPN TRANSISTOR.

KEC
KEC


www.Datenblatt-PDF.com       |      2020       |      Kontakt     |      Suche