|
|
PDF AME8802GEEV Data sheet ( Hoja de datos )
| Número de pieza | AME8802GEEV | |
| Descripción | 300mA CMOS LDO | |
| Fabricantes | Analog Microelectronics | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de AME8802GEEV (archivo pdf) en la parte inferior de esta página. Total 11 Páginas | ||
|
No Preview Available !
Analog Microelectronics, Inc.
AME8802
300mA CMOS LDO
n General Description
The AME8802 family of positive, linear regulators fea-
ture low quiescent current (30µA typ.) with low dropout
voltage, making them ideal for battery applications. The
space-saving SOT-23-5 package is attractive for
"Pocket" and "Hand Held" applications.
These rugged devices have both Thermal Shutdown,
and Current Fold-back to prevent device failure under
the "Worst" of operating conditions.
An additional feature is a "Power Good" detector, which
pulls low when the output is out of regulation.
The AME8802 is stable with an output capacitance of
2.2µF or greater.
n Features
l Very Low Dropout Voltage
l Guaranteed 300mA Output
l Accurate to within 1.5%
l 30µA Quiescent Current
l Over-Temperature Shutdown
l Current Limiting
l Short Circuit Current Fold-back
l Power Good Output Function
l Power-Saving Shutdown Mode
l Space-Saving SOT-25 (SOT-23-5)
l Factory Pre-set Output Voltages
l Low Temperature Coefficient
n Functional Block Diagram
IN
Overcurrent
Shutdown
Thermal
Shutdown
EN
Vref x110%
PG
AMP
OUT
R1
Vref x90%
V ref= 1 . 2 1 5 V
**
R2
GND
** If output voltage specification is lower than 1.215V, Vref will be
trimmed to 1.2V.
n Applications
l Instrumentation
l Portable Electronics
l Wireless Devices
l Cordless Phones
l PC Peripherals
l Battery Powered Widgets
l Electronic Scales
n Typical Application
IN
5V
IN OUT
AME8802
PG GND EN
C1
1 µF
OUT
C2
2 . 2 µF
1
1 page  
Analog Microelectronics, Inc.
AME8802
300mA CMOS LDO
n Detailed Description
The AME8802 family of CMOS regulators contain a
PMOS pass transistor, voltage reference, error ampli-
fier, over-current protection, thermal shutdown, and
power good function.
The P-channel pass transistor receives data from the
error amplifier, over-current shutdown, and thermal pro-
tection circuits. During normal operation, the error am-
plifier compares the output voltage to a precision refer-
ence. Over-current and Thermal shutdown circuits be-
come active when the junction temperature exceeds
150oC, or the current exceeds 300mA. During thermal
shutdown, the output voltage remains low. Normal op-
eration is restored when the junction temperature drops
below 120oC.
The AME8802 switches from voltage mode to current
mode when the load exceeds the rated output current.
This prevents over-stress. The AME8802 also incor-
porates current foldback to reduce power dissipation
when the output is short circuited. This feature becomes
active when the output drops below 0.8volts, and re-
duces the current flow by 65%. Full current is restored
when the voltage exceeds 0.8 volts.
n Enable
The Enable pin normally floats high. When actively,
pulled low, the PMOS pass transistor shuts off, and all
internal circuits are powered down. In this state, the
quiescent current is less than 1µA. This pin behaves
much like an electronic switch.
n Power Good
The AME8802 includes the Power Good feature. Nor-
mally, Pin 4 is "Floating", however, when the output is
not within ±10% of the specified voltage, it pulls low.
This can occur under the following conditions:
1) Input Voltage too low.
2) During Over-Temperature.
3) During Over-Current.
4) If output is pulled up.
n External Capacitors
The AME8802 is stable with an output capacitor to
ground of 2.2µF or greater. Ceramic capacitors have
the lowest ESR, and will offer the best AC performance.
Conversely, Aluminum Electrolytic capacitors exhibit
the highest ESR, resulting in the poorest AC response.
Unfortunately, large value ceramic capacitors are com-
paratively expensive. One option is to parallel a 0.1µF
ceramic capacitor with a 10µF Aluminum Electrolytic.
The benefit is low ESR, high capacitance, and low over-
all cost.
A second capacitor is recommended between the input
and ground to stabilize Vin. The input capacitor should
be at least 0.1uF to have a beneficial effect.
All capacitors should be placed in close proximity to
the pins. A "Quiet" ground termination is desirable.
This can be achieved with a "Star" connection.
5
5 Page 
www.analogmicro.com
E-Mail: [email protected]
Life Support Policy:
These products of Analog Microelectronics, Inc. are not authorized for use as critical components in life-
support devices or systems, without the express written approval of the president
of Analog Microelectronics, Inc.
Analog Microelectronics, Inc. reserves the right to make changes in the circuitry and specifications of its
devices and advises its customers to obtain the latest version of relevant information.
© Analog Microelectronics, Inc., August 2001
Document: 2006-DS8802-E
Corporate Headquarters
Analog Microelectronics, Inc.
3100 De La Cruz Blvd. Suite 201
Santa Clara, CA. 95054-2046
Tel : (408) 988-2388
Fax: (408) 988-2489
Asia Pacific Headquarters
AME, Inc.
2F, 187 Kang-Chien Road, Nei-Hu District
Taipei 114, Taiwan, R.O.C.
Tel : 886 2 2627-8687
Fax : 886 2 2659-2989
11 Page | ||
| Páginas | Total 11 Páginas | |
| PDF Descargar | [ Datasheet AME8802GEEV.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| AME8802GEEV | 300mA CMOS LDO | Analog Microelectronics |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |