Datenblatt-pdf.com


ACT4489 Schematic ( PDF Datasheet ) - Aeroflex Circuit Technology

Teilenummer ACT4489
Beschreibung ACT 4489 SINGLE TRANSCEIVER FOR MIL-STD-1553/1760
Hersteller Aeroflex Circuit Technology
Logo Aeroflex Circuit Technology Logo 




Gesamt 7 Seiten
ACT4489 Datasheet, Funktion
ACT 4489 SINGLE TRANSCEIVER
FOR MIL-STD-1553/1760
Features
• +5 / ±12 Volt Supply Operation
CIRCUIT TECHNOLOGY
www.aeroflex.com/act1.htm
• Low Power Dissipation
• Small Size & Light Weight
• Outstanding MIL-STD-1553 performance
• Radiation Hard Dielectric Isolation Monolithic
Construction for Severe Environments
• Superior High Frequency Line Transient and
Input Ripple Rejection
• Input and Output TTL Compatible Design
• Processed and Screened to MIL-STD-883 Specs
• MIL-PRF-38534 Compliant Devices Available
TX DATA IN
TX DATA IN
TX INHIBIT IN
+5V (VL)
+12V (VCC)
-12V (VEE)
GND1
GND2
GND3
RX DATA IN
RX DATA IN
CASE
RX STROBE IN
DRIVER
INPUT
AMPLIFIER
ACTIVE
FILTER
REFERENCE
ACTIVE
FILTER
OUTPUT
STAGE
TX DATA OUT
TX DATA OUT
COMP.
RX DATA OUT
COMP.
RX DATA OUT
Block Diagram (Without Transformer)
General Description
The Aeroflex Circuit
Technology ACT 4489 is a next
generation monolithic transceiver
design which provides full
compliance to MIL-STD-1553A/B
and 1760 requirements in a small
package with low power
consumption.
The ACT 4489 series performs
the front-end analog function of
inputting and outputting data
through a transformer to the
MIL-STD-1553 data bus.
Design of this transceiver reflects
particular attention to active filter
performance. This results in low bit
and word error rate with superior
waveform purity and minimal zero
crossover distortion. Efficient
transmitter electrical and thermal
design provides low internal power
dissipation and heat rise at high as
well as low duty cycles.
Transmitter:
The Transmitter section accepts
bi-phase TTL data at the input and
when coupled to the data bus with a
1:1 ratio transformer, isolated on
the data bus side with two 52.5
Ohm fault isolation resistors, and
loaded by two 70 Ohm
terminations, the data bus signal is
typically 7 Volts P-P at point A (See
Figure 5). When both DATA and
DATA inputs are held low or high,
the transmitter output becomes a
high impedance and is “removed”
from the line. In addition, an
overriding “INHIBIT" input provides
eroflex Circuit Technology – Data Bus Modules For The Future © SCD4489 REV A 1/29/98






ACT4489 Datasheet, Funktion
Figure 6 – Lead Numbers & Functions
ACT4489
Pin # Function
1 TX DATA OUT
2 TX DATA OUT
3 GROUND
4 NC
5 NC
6 NC
7 RX DATA OUT
8 STROBE
9 GROUND
10 RX DATA OUT
11 NC
12 NC
13 VCC
14 NC
15 RX DATA IN
16 RX DATA IN
17 NC
18 CASE
19 VEE
20 +5 V
21 TX INHIBIT
22 TX DATA IN
23 TX DATA IN
24 NC
Aeroflex Circuit Technology
6 SCD4489 Rev A 1/29/98 Plainview NY (516) 694-6700

6 Page







SeitenGesamt 7 Seiten
PDF Download[ ACT4489 Schematic.PDF ]

Link teilen




Besondere Datenblatt

TeilenummerBeschreibungHersteller
ACT4480-DFIDual TransceiverAeroflex Circuit Technology
Aeroflex Circuit Technology
ACT4487Dual TransceiverAeroflex Circuit Technology
Aeroflex Circuit Technology
ACT4487Dual TransceiverAeroflex Circuit Technology
Aeroflex Circuit Technology
ACT4487Single TransceiverAeroflex Circuit Technology
Aeroflex Circuit Technology
ACT4489ACT 4489 SINGLE TRANSCEIVER FOR MIL-STD-1553/1760Aeroflex Circuit Technology
Aeroflex Circuit Technology

TeilenummerBeschreibungHersteller
CD40175BC

Hex D-Type Flip-Flop / Quad D-Type Flip-Flop.

Fairchild Semiconductor
Fairchild Semiconductor
KTD1146

EPITAXIAL PLANAR NPN TRANSISTOR.

KEC
KEC


www.Datenblatt-PDF.com       |      2020       |      Kontakt     |      Suche