Datenblatt-pdf.com


ACT4436-DFI Schematic ( PDF Datasheet ) - Aeroflex Circuit Technology

Teilenummer ACT4436-DFI
Beschreibung ACT 4436 DUAL TRANSCEIVER FOR MIL-STD-1553/1760
Hersteller Aeroflex Circuit Technology
Logo Aeroflex Circuit Technology Logo 




Gesamt 7 Seiten
ACT4436-DFI Datasheet, Funktion
ACT 4436 DUAL TRANSCEIVER
FOR MIL-STD-1553/1760
Features
5 Smaller Case Outline than ACT4487D
CIRCUIT TECHNOLOGY
www.aeroflex.com/act1.htm
• +5 / ±15 Volt Supply Operation
• Low Power Dissipation
• Outstanding MIL-STD-1553 performance
• Radiation Hard Dielectric Isolation Monolithic
Construction for Severe Environments
• Input and Output TTL Compatible Design
• Processed and Screened to MIL-STD-883 Specs
• MIL-PRF-38534 Compliant Devices Available
• DESC SMD# 5962-89447
TX DATA IN
TX DATA IN
TX INHIBIT IN
+5V (VL)
+15V (VCC)
-15V (VEE)
GND1
GND2
GND3
RX DATA IN
RX DATA IN
CASE
RX STROBE IN
DRIVER
INPUT
AMPLIFIER
ACTIVE
FILTER
REFERENCE
ACTIVE
FILTER
OUTPUT
STAGE
TX DATA OUT
TX DATA OUT
COMP.
RX DATA OUT
COMP.
RX DATA OUT
Block Diagram (Without Transformer)
General Description
The Aeroflex Circuit Technology
ACT 4436 is a next generation
monolithic transceiver design
which provides full compliance to
MIL-STD-1553A/B and 1760 re-
quirements in a smaller package
with lower pin count then the
ACT4487D, for those designs with
less board space.
The ACT 4436 series performs
the front-end analog function of
inputting and outputting data
through a transformer to the
MIL-STD-1553 data bus.
Design of this transceiver reflects
particular attention to active filter
performance. This results in low bit
and word error rate with superior
waveform purity and minimal zero
crossover distortion. Efficient
transmitter electrical and thermal
design provides low internal power
dissipation and heat rise at high as
well as low duty cycles.
Transmitter:
The Transmitter section accepts
bi-phase TTL data at the input and
when coupled to the data bus with a
1.4:1 ratio transformer, isolated on
the data bus side with two 52.5
Ohm fault isolation resistors, and
loaded by two 70 Ohm
terminations, the data bus signal is
typically 7.5 Volts P-P at point A
(See Figure 5). When both DATA
and DATA inputs are held low or
high, the transmitter output
becomes a high impedance and is
“removed” from the line. In addition,
eroflex Circuit Technology – Data Bus Modules For The Future © SCD4436D REV B 3/10/98






ACT4436-DFI Datasheet, Funktion
Figure 6 – Lead Numbers & Functions
ACT4436D – Plug In and Flat Package
Pin #
Function
Channel
1 TX DATA OUT/ RX DATA IN
A
2 TX DATA OUT/ RX DATA IN
A
3 GROUND
A
4 RX STROBE
A
5 RX DATA OUT
A
6 RX DATA OUT
A
7 CASE
A
8 TX DATA OUT/ RX DATA IN
B
9 TX DATA OUT/ RX DATA IN
B
10 GROUND
B
11 RX STROBE
B
12 RX DATA OUT
B
13 RX DATA OUT
B
14 NC
B
15 GROUND
B
16 -V
B
17 VL
B
18 TX INHIBIT
B
19 TX DATA IN
B
20 TX DATA IN
B
21 +V
B
22 GROUND
A
23 -V
A
24 VL
A
25 TX INHIBIT
A
26 TX DATA IN
A
27 TX DATA IN
A
28 +V
A
Aeroflex Circuit Technology
6 SCD4436D REV B 3/10/98/98 Plainview NY (516) 694-6700

6 Page







SeitenGesamt 7 Seiten
PDF Download[ ACT4436-DFI Schematic.PDF ]

Link teilen




Besondere Datenblatt

TeilenummerBeschreibungHersteller
ACT4436-DFACT 4436 DUAL TRANSCEIVER FOR MIL-STD-1553/1760Aeroflex Circuit Technology
Aeroflex Circuit Technology
ACT4436-DFIACT 4436 DUAL TRANSCEIVER FOR MIL-STD-1553/1760Aeroflex Circuit Technology
Aeroflex Circuit Technology

TeilenummerBeschreibungHersteller
CD40175BC

Hex D-Type Flip-Flop / Quad D-Type Flip-Flop.

Fairchild Semiconductor
Fairchild Semiconductor
KTD1146

EPITAXIAL PLANAR NPN TRANSISTOR.

KEC
KEC


www.Datenblatt-PDF.com       |      2020       |      Kontakt     |      Suche