DataSheet.es    


PDF PAH8001EI-2G Data sheet ( Hoja de datos )

Número de pieza PAH8001EI-2G
Descripción Optical Heart Rate Detection Sensor
Fabricantes PixArt 
Logotipo PixArt Logotipo



Hay una vista previa y un enlace de descarga de PAH8001EI-2G (archivo pdf) en la parte inferior de esta página.


Total 28 Páginas

No Preview Available ! PAH8001EI-2G Hoja de datos, Descripción, Manual

深圳市义嘉详科技有限公司
Tel:89486115 QQ:2355427751
www.szgsensor.com
PAH8001EI-2G
Optical Heart Rate Detection Sensor
General Description
The PAHEI-2GEI-2G is a high performance and low power CMOS-process optical sensor with Green LED and DSP
integrated serving as a Heart Rate Detection (HRD) sensor. It is based on optical technology which measures the
variation of human blood movement in the vessel.
Key Features
Heart rate detection function (HRD)
Ultra-low power consumption, power saving mode
during time of no touch movement
- LPT sleep1
- LPT sleep2
Flexible sleep rate control
Flexible communication interface
- I2C
- 4-wire SPI
- 2-wire SPI
I2C interface up to 1 Mbit/s
SPI interface up to 1 Mbit/s
Hardware reset support
Hardware power down support
Integrated chip-on-board LED with wavelength of
525nm
Key Sensor Performance
Parameter
Max. frame rate
Value
3000 fps
VDDM: 3.0~3.6V
VDDIO: 1.62~3.6V
Supply voltage
Power consumption
Note: suggest customer could
consider 3.3V to avoid voltage
drop issue.
1.5 mA at Normal mode
160 uA at Sleep1 mode
40 uA at Sleep2 mode
15uA at power down mode
Operating temperature
(at junction)
Package
Note: including LED current, w/o I/O
toggling, package only
-20 to +60 °C
Land Grid Array. Size 3.0 x 4.7 mm
with 16 pins
Applications
Healthcare on wearable device
Photoplethysmogram waveform
Ordering Information
Part Number
Packing
PAH8001EI-2G 16-Pin LGA
Description
CMOS HRD optical sensor
All rights strictly reserved. Any portion in this paper shall not be reproduced, copied or transformed to any other forms without permission.
1
PixArt Imaging Inc. E-mail:[email protected]
Preliminary Datasheet V0.9 Jul. 2014

1 page




PAH8001EI-2G pdf
深圳市义嘉详科技有限公司
Tel:89486115 QQ:2355427751
www.szgsensor.com
PAH8001EI-2G
Optical Heart Rate Detection Sensor
Package Outline Dimension and Recommend
Layout PCB
Figure 3. Package Outline Drawing
Figure 4. Recommend Layout PCB
All rights strictly reserved. Any portion in this paper shall not be reproduced, copied or transformed to any other forms without permission.
5
PixArt Imaging Inc. E-mail:[email protected]
Preliminary Datasheet V0.9 Jul. 2014

5 Page





PAH8001EI-2G arduino
深圳市义嘉详科技有限公司
Tel:89486115 QQ:2355427751
www.szgsensor.com
PAH8001EI-2G
Optical Heart Rate Detection Sensor
2. Four-Wire SPI Interface (For PAH8001EI-2G)
CSN_ID1 : Chip select line, active low(Generally named SPI_CS).
SCK : Serial clock line, generated by the host controller.
CSN_ID0 : Serial data line, used to write data to sensor(Generally named MOSI).
SDIO : Serial data line, used to read data from sensor(Generally named MISO).
2.1. Transmission Protocol
The transmission protocol is a 4-wire link, half duplex protocol between the micro-controller and the sensor. All data
changes on SDI_ID0/SDIO are latched at SCK rising edge. The host controller always initiates communication and the
sensor never initiates data transfers.
The transmission protocol consists of the two operation modes:
- Write Operation.
- Read Operation.
Both of the two operation modes consist of two bytes. The first byte contains the address (seven bits) and has a bit 7 as
its MSB to indicate data direction. The second byte contains the data.
F IR S T B Y T E
R/W
(1 B IT )
A D D R E S S (7 B IT )
SECOND BYTE
D A T A (8 B IT )
MSB
LSB MSB
LSB
Figure 9. Four-wire SPI Transmission protocol
2.2. Write/Read Operation
Write Operation
A write operation, which means that data is going from the host controller to the sensor, is always initiated by the
controller and consists of two bytes. The first byte contains the address (seven bits) and has a “1” as its MSB to
indicate data direction. The second byte contains the data. The transfer is synchronized by SCK. The controller changes
SDI_ID0 at SCK falling edges. The sensor reads SDI_ID0at SCK rising edges.
Figure 10. Four-wire SPI Write operation
All rights strictly reserved. Any portion in this paper shall not be reproduced, copied or transformed to any other forms without permission.
11
PixArt Imaging Inc. E-mail:[email protected]
Preliminary Datasheet V0.9 Jul. 2014

11 Page







PáginasTotal 28 Páginas
PDF Descargar[ Datasheet PAH8001EI-2G.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
PAH8001EI-2GOptical Heart Rate Detection SensorPixArt
PixArt

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar