Datenblatt-pdf.com


P8H61-I Schematic ( PDF Datasheet ) - ASUS

Teilenummer P8H61-I
Beschreibung Motherboard Manual
Hersteller ASUS
Logo ASUS Logo 




Gesamt 30 Seiten
P8H61-I Datasheet, Funktion
P8H61-I






P8H61-I Datasheet, Funktion
Notices
Federal Communications Commission Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with manufacturer’s instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
The use of shielded cables for connection of the monitor to the graphics card is required
to assure compliance with FCC regulations. Changes or modifications to this unit not
expressly approved by the party responsible for compliance could void the user’s authority
to operate this equipment.
Canadian Department of Communications Statement
This digital apparatus does not exceed the Class B limits for radio noise emissions from
digital apparatus set out in the Radio Interference Regulations of the Canadian Department
of Communications.
This class B digital apparatus complies with Canadian ICES-003.
REACH
Complying with the REACH (Registration, Evaluation, Authorisation, and Restriction of
Chemicals) regulatory framework, we published the chemical substances in our products at
ASUS REACH website at http://csr.asus.com/english/REACH.htm.
DO NOT throw the motherboard in municipal waste. This product has been designed to
enable proper reuse of parts and recycling. This symbol of the crossed out wheeled bin
indicates that the product (electrical and electronic equipment) should not be placed in
municipal waste. Check local regulations for disposal of electronic products.
DO NOT throw the mercury-containing button cell battery in municipal waste. This symbol
of the crossed out wheeled bin indicates that the battery should not be placed in municipal
waste.
vi

6 Page









P8H61-I pdf, datenblatt
1.2
1.2.1
Motherboard overview
Motherboard layout
Ensure that you install the motherboard into the chassis in the correct orientation. The edge
with external ports goes to the rear part of the chassis.
1
KB_USB56
HDMI
IT
8756E
23
4
17.1cm(6.75in)
5
6
Intel®
H61
SATA1
SATA2
CPU_FAN CHA_FAN
SATA3
SATA4
32Mb
BIOS
ATX12V
USB34
ASM
1042
LAN1_USB3_12
AUDIO
RTL
8111E
AAFP
VIA
VT1708S
SPDIF_OUT
LGA1155
EPU
PCI1EX16
2
SB_PWR
CLRTC
7
8
11 10
9
Place four screws into the holes indicated by circles to secure the motherboard to the
chassis. DO NOT overtighten the screws! Doing so can damage the motherboard.
1.2.2 Layout contents
Connectors/Jumpers/Slots/LED
1. USB 2.0 connector (10-1 pin USB910,
USB1112)
2. ATX power connectors (24-pin EATXPWR,
4-pin ATX12V)
3. Intel® LGA1155 CPU socket
4. Intel® H61 Serial ATA 3.0Gb/s connectors
(7-pin SATA3G_1/2/3/4)
5. CPU and chassis fan connectors (4-pin
CPU_FAN, 4-pin CHA_FAN)
6. DDR3 U-DIMM slots
Page
1-16 7.
Connectors/Jumpers/Slots/LED
Page
System panel connector (10-1 pin F_PANEL) 1-15
1-12 8. Standby power LED (SB_PWR)
1-1
1-3 9. Clear RTC RAM (3-pin CLRTC)
1-9
1-14 10. Digital audio connector (4-1 pin SPDIF_OUT) 1-13
1-13 11. Front panel audio connector (10-1 pin AAFP) 1-16
1-3
ASUS P8H61-I
1-2

12 Page





SeitenGesamt 30 Seiten
PDF Download[ P8H61-I Schematic.PDF ]

Link teilen




Besondere Datenblatt

TeilenummerBeschreibungHersteller
P8H61-IMotherboard ManualASUS
ASUS
P8H61-MMotherboard ManualASUS
ASUS
P8H61-MXMotherboard ManualASUS
ASUS

TeilenummerBeschreibungHersteller
CD40175BC

Hex D-Type Flip-Flop / Quad D-Type Flip-Flop.

Fairchild Semiconductor
Fairchild Semiconductor
KTD1146

EPITAXIAL PLANAR NPN TRANSISTOR.

KEC
KEC


www.Datenblatt-PDF.com       |      2020       |      Kontakt     |      Suche