|
|
PDF AD9876 Data sheet ( Hoja de datos )
| Número de pieza | AD9876 | |
| Descripción | Broadband Modem Mixed-Signal Front End | |
| Fabricantes | Analog Devices | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de AD9876 (archivo pdf) en la parte inferior de esta página. Total 24 Páginas | ||
|
No Preview Available !
aA
Broadband Modem
Mixed-Signal Front End
AD9876
FEATURES
Low Cost 3.3 V CMOS Mixed-Signal Front End (MxFE™)
Converter for Broadband Modems
10-/12-Bit D/A Converter (TxDAC+®)
64/32 MSPS Input Word Rate
2؋/4؋ Interpolating LPF or BPF Transmit Filter
128 MSPS DAC Output Update Rate
Wide (26 MHz) Transmit Bandwidth
Power-Down Mode
10-/12-Bit 50 MSPS A/D Converter
Fourth Order Low-Pass Filter 12 MHz or 26 MHz
with Bypass
–6 dB to +36 dB Programmable Gain Amplifier
Internal Clock Multiplier (PLL)
Clock Outputs
Voltage Regulator Controller
48-Lead LQFP Package
APPLICATIONS
Powerline Networking
Home Phone Networking
xDSL
Broadband Wireless
Home RF
PWR DN
Tx QUIET
GAIN
Tx [5:0]
Tx SYNC
FUNCTIONAL BLOCK DIAGRAM
AD9876
Tx
12 12
Kx INTERPOLATION
MUX
LPF/BPF
TxDAC+
Tx+
Tx–
CLK-A
CLK-B
Rx SYNC
PLL-A
؋L
CLOCK GEN
PLL-B
؋ M/N
VREF
VRC
GATE
FB
OSCIN
XTAL
Rx [5:0]
Rx
MUX 12
ADC
PGA
Rx+
LPF PGA
Rx–
SPORT 3
REGISTER
CONTROL
PRODUCT DESCRIPTION
The AD9876 is a single-supply broadband modem mixed-signal
front end (MxFE) IC. The device contains a transmit path
interpolation filter and DAC and a receive path PGA, LPF, and
ADC supporting a variety of broadband modem applications.
Also on-chip is a PLL clock multiplier that provides all required
clocks from a single crystal or clock input. The AD9876 provides
12-bit converter performance on both the Tx and Rx path.
The TxDAC+ uses a selectable digital 2× or 4× interpolation
low-pass or band-pass filter to further oversample transmit data
and reduce the complexity of analog reconstruction filtering.
The transmit path signal bandwidth can be as high as 26 MHz
at an input data rate of 64 MSPS. The 12-bit DAC provides
differential current outputs for optimum noise and distortion
performance. The DAC full-scale current can be adjusted from
2 to 20 mA by a single resistor, providing 20 dB of additional
gain range.
The receive path consists of a PGA, LPF, and ADC. The PGA has
a gain range of –6 dB to +36 dB, programmable in 2 dB steps,
adding 42 dB of dynamic range to the receive path. The receive
path LPF cutoff frequency can be programmed to either 12 MHz
or 26 MHz. The filter cutoff frequency can also be tuned or
bypassed where filter requirements differ. The 12-bit ADC uses
a multistage differential pipeline architecture to achieve excellent
dynamic performance with low power consumption.
The AD9876 provides a voltage regulator controller (VRC) that
can be used with an external power MOSFET transistor to form
a cost-effective 1.3 V linear regulator.
The digital transmit and receive ports are each multiplexed to a
bus width of six bits and are clocked at a frequency of twice the
12-bit word rate.
The AD9876 ADC and/or DAC can also be used at sampling
rates as high as 64 MSPS in a 6-bit resolution nonmulti-
plexed mode.
The AD9876 is pin compatible with the 10-bit AD9875. Both are
available in a space-saving 48-lead LQFP package. They are speci-
fied over the industrial (–40°C to +85°C) temperature range.
MxFE is a trademark of Analog Devices, Inc.
TxDAC+ is a registered trademark of Analog Devices, Inc.
REV. A
Information furnished by Analog Devices is believed to be accurate and
reliable. However, no responsibility is assumed by Analog Devices for its
use, nor for any infringements of patents or other rights of third parties that
may result from its use. No license is granted by implication or otherwise
under any patent or patent rights of Analog Devices.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781/329-4700
F2ax: 781/326-8703
www.analog.com
© Analog Devices, Inc., 2002
1 page  
AD9876
ABSOLUTE MAXIMUM RATINGS*
Power Supply (VS) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.9 V
Digital Output Current . . . . . . . . . . . . . . . . . . . . . . . . . 5 mA
Digital Inputs . . . . . . . . . . . . . . . –0.3 V to DRVDD + 0.3 V
Analog Inputs . . . . . . . . . . . . . . . . . –0.3 V to AVDD + 0.3 V
Operating Temperature . . . . . . . . . . . . . . . . . –40°C to +85°C
Maximum Junction Temperature . . . . . . . . . . . . . . . . 150°C
Storage Temperature . . . . . . . . . . . . . . . . . . –65°C to +150°C
Lead Temperature (Soldering 10 sec) . . . . . . . . . . . . . 300°C
*Stresses greater than those listed under Absolute Maximum Ratings may cause
permanent damage to the device. This is a stress rating only; functional operation
of the device at these or any other conditions above those indicated in the
operational section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect device reliability.
EXPLANATION OF TEST LEVELS
I – Devices are 100% production tested at 25°C and guaran-
teed by design and characterization testing for industrial
operating temperature range (–40°C to +85°C).
II – Parameter is guaranteed by design and/or characteriza-
tion testing.
III – Parameter is a typical value only.
THERMAL CHARACTERISTICS
Thermal Resistance
48-Lead LQFP
JA = 57°C/W
JC = 28°C/W
Model
AD9876BST
AD9876-EB
AD9876BSTRL
Temperature Range
–40°C to +85°C
–40°C to +85°C
–40°C to +85°C
ORDERING GUIDE
Package Description
48-Lead LQFP
Evaluation Board
BST Reel
Package Option
ST-48
CAUTION
ESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000 V readily
accumulate on the human body and test equipment and can discharge without detection. Although
the AD9876 features proprietary ESD protection circuitry, permanent damage may occur on
devices subjected to high energy electrostatic discharges. Therefore, proper ESD precautions are
recommended to avoid performance degradation or loss of functionality.
WARNING!
ESD SENSITIVE DEVICE
REV. A
–5–
5 Page 
AD9876
Typical Tx Digital Filter Performance Characteristics
40
38
36
34
32
30
28
26
24
22
20
64 80 96 112 128 144 160 176 192
18
17
16
15
14
13
12
11
10
9
8
48 64 80 96 112 128 144 160 176 192
TPC 17. Rx vs. Tuning Target, fADC = 32 MHz,
LPF with Wideband Rx LPF = 1
TPC 19. fC vs. Tuning Target, fADC = 32 MHz,
LPF with Wideband Rx LPF = 0
0.60
0.40
0.20
0.00
–0.20
–0.40
–0.60
–0.80
–6 –4 –2 0 2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36
VGA GAIN – dB
TPC 18. PGA Gain Error vs. Gain
2.5
2.4
2.3
2.2
2.1
2.0
1.9
1.8
1.7
1.6
1.5
–6 –4 –2 0 2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36
VGA GAIN – dB
TPC 20. PGA Gain Step Size vs. Gain
REV. A
–11–
11 Page | ||
| Páginas | Total 24 Páginas | |
| PDF Descargar | [ Datasheet AD9876.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| AD9870 | IF Digitizing Subsystem | Analog Devices |
| AD9873 | Analog Front End Converter for Set-Top Box/ Cable Modem | Analog Devices |
| AD9874 | IF Digitizing Subsystem | Analog Devices |
| AD9875 | Broadband Modem Mixed-Signal Front End | Analog Devices |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |